Question about 2008 Toyota Tacoma

1 Answer

There are blanks where switches go on my 2008 tacoma. There are wires attached to these blanks. Where can I find out what they are for?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 43 Answers

THEY'RE FOR ANY EXTRA ACCESSORY THAT TOYOTA HAS FOR THAT MODEL, THERE ARE NO WIRES DIRECTLY ATTACHED TO THEM.

Posted on Sep 23, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to replace spark plugs on a 2008 Toyota Tacoma 4 cyl


Not a difficult job, but difficult to outline without photo/video aid.

Short list, using compressed air, blow out all of the junk that has collected under the intake muffler, then remove the muffler from the throttle body and airbox There are two large hoses, plus two small hoses, one on the rear (crankcase vent) and one in front. There is also a wire harness on the rear that needs to be separated.



Once removed, make sure the top of the cam cover is clean, unplug the wiring harness from the coil packs, remove the bolts (10mm socket), and pull the coil packs from the plugs. The rear plug is a bit of a pain because of the wiring harnesses, but you can carefully separate them and move them out of the way.



The Tacoma 2.7 uses Iridium plugs. Stick with the OEM Denso plugs, don\'t fall for the snake oil salesmen pushing 4 electrode or special "hot spark" designs.

Jun 07, 2014 | 2008 Toyota Tacoma

1 Answer

How do install a light under my hood for a 2008 tacoma


Should be able to pick up an aftermarket light with a gravity switch, and tie it into a battery power circuit with an inline fuse.

Apr 11, 2013 | 2008 Toyota Tacoma

1 Answer

S on 2008 4 cyl tacoma prerunner


Obtain a Hayne's Repair Manual. They go over spark plug replacement.

May 05, 2012 | 2008 Toyota Tacoma

1 Answer

Why does my 2008 Tacoma blow the eg1 fuse everytime I shift out of park?


Hi Austin, You must have a short circuit in the wiring. Regards John

Apr 25, 2012 | 2008 Toyota Tacoma

1 Answer

I have a 2008 toyota tacoma Prerunner. when I use the alarm remote to lock the doors, all doors close except the front driver side. I also noticed that no sound is made when i arm or disarm the alarm. ...


Hello! There is a Technical Service Bulletin # EL009-07 that addresses programing the door lock remote...Your dealer should have a copy...I mention the TSB up front as a possible solution to the problem...However I believe the drivers side Door Lock Assembly is defective or the wiring to the switch/motor is open...The assembly has a 4 pin connector...White/Red and White/Black are the switch contacts... Blue/Black and Blue/Red are the lock drive motor...If you have the expertise, gain access to the assembly and inspect the connector and test with a multimeter...If you are not comfortable doing that I would replace the assembly...

Guru............Saailer

Feb 01, 2011 | 2008 Toyota Tacoma

2 Answers

How to repair the accessory meter on a 2008 tacoma?@@


These consoles are notorious for going bad. You can get a new one at the dealership for $250 (!!!), grab one from a wrecker, or I offer a repair solution with a lifetime guarantee. Check out www.autoclockrepair.com I have removal instructions and info there. Please let me know if I can be of further help, thanks!

Jan 03, 2011 | 2008 Toyota Tacoma

1 Answer

Where is the airbag fuse in 08 tacoma


under the hood.. maun fuse box .. make sure dealer scans system after replacement.. just to be safe

Aug 03, 2009 | 2008 Toyota Tacoma

1 Answer

2008 Pontiac Grand Prix Factory stereo color codes


attach both power and illumination wires to constant on car wires.... only way to have switched power is connecting the switched/ignition wire to a fuse

Feb 02, 2009 | 2008 Pontiac Grand Prix

Not finding what you are looking for?
2008 Toyota Tacoma Logo

Related Topics:

167 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8522 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...