Question about 1997 Jeep Wrangler

1 Answer

97 jeep wrangler 4.0 L will not start , power to all , fuel ok , but the fuel gauge and the batery gauge will not move when turn key on , engine will turn over but not start, checked all fuses and relays seem ok whot could be the problem? Jeep was running wife put it in park left it running and the jeep just stoped running?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

  • Expert
  • 47 Answers

Check the wire near Diesel pump solnid, put a wire from +ve teminal of bettery check the solnid is working or not?

Posted on Sep 23, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

95 jeep wrangler 2.5L fi.very long crank time before engine starts.this system requires rpm signal before it will power up fuel pump.


Key on engine off , what is the fuel pressure ? When you turn the key to the on position ( not start ) the PCM will turn the fuel pump on for two or three seconds for system prim , then it needs a RPM signal (engine cranking) . In side the fuel pump module is a check valve that keeps pressure in the fuel lines , if weak will allow fuel to drain back to the fuel tank . This will cause long crank times . Put a fuel pressure gauge on the vehicle an see what the pressure is key on , does it come up to 40 psi ?

Oct 06, 2016 | Jeep Cars & Trucks

1 Answer

97 Jeep Wrangler sport- Cranks, will not


Fuel flow. Either simply, a blocked fuel line (debris / filter / fouled gas) or an electronic issue. Ever let this Jeep run bone dry on gas? Hopefully not, as doing so can draw a lot of crud into your fuel lines from the bottom of the tank. Electronically, if part of the Jeep "brain" has gone bad, there may not be any fuel being routed to the engine. This most likely needs a Jeep mechanic to repair.

May 15, 2010 | 2007 Jeep Wrangler Unlimited Rubicon 2...

1 Answer

What should the fuel pressure be for a 2003 jeep wrangler


1. Connect fuel pressue gauge, start engine
2. Observe test gauge. Normal operating pressure should be 339kPa+/- 34 kPa (49.2 psi +/- 5 psi
3. Turn vehicle off.
4. Pressure should not fall below 30 psi for 5 minutes

i have these directions plus more about if want in pdf format, need email address to send if want

Feb 04, 2010 | 2003 Jeep Wrangler

1 Answer

2001 Jeep Cherokee - Cranks won't start - Gas gauge "E" w/gas


Disconnect and replace fuel filter.With filter disconnected have someone momentarily turn key to on position to see is fuel pump is working.Make sure you have lots of rags,a drain pan and safety goggles on

Sep 11, 2009 | 1993 Jeep Grand Cherokee

3 Answers

97 Jeep Wrangler turns over but wont start


Replace the pump fuel solinoid.That only allows fuel through when the ignition is swiched on and its that is the fault good luck.

Aug 01, 2009 | 1997 Jeep Wrangler

1 Answer

1997 2.5L CRANK NO START


clog in your fuel line or you need to change your fuel filter.

Jul 09, 2009 | 1997 Jeep Wrangler

1 Answer

95 jeep wrangler: gauge indicates 0 oil pressure


Wire on oil sending unit may have fallen off or sensor itself may have gone bad. Check both. If engine has no tapping noises, likely it's not a pressure problem.

Jun 07, 2009 | 1998 Jeep Wrangler

2 Answers

97 Jeep Wrangler Dash Gauges Arent Operating..everything else ok!


ck the engine to body ground.located back side of engine and srew to firewall.

Jun 01, 2009 | 1997 Jeep Wrangler

3 Answers

97 Jeep Wrangler Dash Gauges Arent Operating..everything else ok!


check fuse #17 in fuse box under hood. It's a 10 red fuse. that's how i fixed my problem.

Dec 20, 2008 | 1997 Jeep Wrangler

Not finding what you are looking for?
1997 Jeep Wrangler Logo

412 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...