Question about Cars & Trucks
and follow the site instructions.
Good luck and rate this solution.
Posted on Sep 23, 2009
Im looking for the radio code numberi dont have the serial number hyundai accent 2005
Posted on Jun 13, 2011
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
dear friend:the hyundai radio"s does not come with a security code,which means that it is a after market unit and you have to contact the manufacturer with the serial no:
Posted on Sep 23, 2009
A car can overheat for a lot of reasons.First make sure this is the problem by checking the radiator hose or water level. Open the radiator cap when the car is cold, crank it, and then watch the water level. If it drops when the car warms up this is not the problem.
The tools you will need will depend on what you have to take off to get to it. If you can access the thermostat you should only need a ratchet or wrench to remove it and something to scrape off old gasket with.
Location:The thermostat should be inside the thermostat housing on the motor. Follow your top radiator hose to the place where it goes into the motor. There should be a sort of dome shaped housing there with probably a bolt on either side of it.The thermostat is inside that.
This is a reasonably easy job, but shouldn't be done carelessly. It's also kind of messy.
When the car is cold remove the bolts from the housing with a ratchet. Lots of coolant and water will drain out. But the thermostat will be visible.Pay attention to which side of the thermostat is up.It should just lift up. Remove all the old gasket from around the area and clean it up well. Replace the thermostat and gasket then the bolts. Be very careful not to over tighten the bolts or the housing will be ruined.
Posted on Apr 22, 2009
You have to take out the ash tray, and remove those two screws, then pop out the center dash trim. Careful, though, you have to take out a lot of the wiring inside of your center dash trim in order to pull it out for enough room to move the radio in and out. I'm doing this right now, actually..
Posted on May 22, 2009
these radios the code is installed by the dealership or the manufacture of the radio so what yo can do is to either call the dealership and give them the radios information or take the car to the dealership and they can do it there for you and somtimes it yo look at your users manual the code will be in there and it will explain the steps to program it ok
Hope this is very helpful for you.
Best regards Michael
Posted on Dec 16, 2009
Tips for a great answer:
May 26, 2015 | Hyundai Cars & Trucks
Jun 28, 2012 | 2005 Hyundai Accent
Apr 04, 2010 | 2005 Hyundai Accent
Feb 12, 2010 | 2005 Hyundai Accent
Feb 12, 2010 | 2001 Hyundai Accent
Feb 08, 2010 | 2005 Hyundai Accent
Sep 22, 2009 | 2005 Hyundai Accent
Aug 31, 2009 | 2005 Hyundai Accent
Sep 07, 2008 | Hyundai Motor 1995 Accent
821 people viewed this question
Usually answered in minutes!