Where is the cam sensor located on a dodge v10

My info says front top of engine near water outlet. You can also check the wiring colors at sensor to double check, use wiring diagrams to get wire color.

It is part of the throttle body.

Bank 1 is the side that has Cylinder # 1 (drivers side on your engine) Sensor 1 is the one BEFORE the cat. Sensor #2 is AFTER the cat. Bank 2 is the side that has Cylinder #2 (passsenger side on your engine) and again sensor #1 is BEFORE and sensor #2 is AFTER. I have seen dodge use a 5th one on the V10 after the two exhaust pipes are joined together. that's the only place a #3 sensor could be that I know of. I don't know if they did this on the 5.2 V8.

check the timing on the distributor gear to cam it may have moved on you

Crank sensor is in the bell housing of the transmission. Cam sensor is in the distributor.

The cam position sensor on the 2.7 engine is on the
driver side of your engine, right in the front of the head. there's a 10mm bolt. undo the bolt and pull it straight out. push the new one into the hole, and hold pressure on it until it's bolted back in.

If you have the 3.5, the cam position sensor is located on top of the timing cover. I just unbolt the upper intake just enough to lift it up a little. unbolt the cam sensor, pull it out and install the new one keeping pressure on it until it's bolted in.

I hope this helps

Answer

picREMOVAL - 4.7L
The Camshaft Position Sensor (CMP) on the 4.7L V–8 engine is bolted to the front/top of the right cylinder head (CMP Location—4.7L Engine).

It is easier to remove/install sensor from under vehicle.

Raise and support vehicle.
Disconnect electrical connector at CMP sensor (CMP Location—4.7L Engine).
Remove sensor mounting bolt (CMP Location—4.7L Engine).
Carefully twist sensor from cylinder head.
Check condition of sensor o-ring.

CAMSHAFT POSITION SENSOR 2001 Dodge Truck RAM 1500 1/2 ton 2WD 5.9L SFI 8cyl The Camshaft Position Sensor is located: Under hood, center, upper engine area, rear of intake manifold, mounted in distributor

If this is helpful.Please leave ositive Feedback. Thanks, SnugglePants

Do need you to know where the sensor is located ? If so it's located inside distributor housing, just below rotor on (3.9L-V6 5.2L-V8 5.9-V8) 8.0L-V10 cam sensor is located on the timing chain cover.