Question about 2003 Jeep Wrangler

2 Answers

Jeep shuts down, ac doen't work properly and raido comes on and off when it wants to.

Posted by on


2 Answers

  • Level 1:

    An expert who has achieved level 1.


    An expert that has over 10 points.


    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

You have an electrical short and it sounds like it's in the dash. You need to check the wiring. If you have squirls or mice anywhere around they may have gotten up in there to make a home. I had to replace a complete wiring harness thanks to a squirl. Hope that helps you.

Posted on Sep 20, 2009

Testimonial: "thanks for the tip, I,ll buy a bb gun."

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 4,088 Answers

Try removing and reinserting all of the fuses and relays in the power center box. Jeeps tend to loosen things when traveling on rough roads. Also, check every ground point on the car for looseness or corrosion.

Posted on Sep 20, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Need input on engine code for engine temp staying low too long

Have you not googled your obd codes
& diagnosed them, to find a problem

No idea why you would do all you did

You always resolve code related issues first

The coolant temp should be 210 all the time

Sounds like your not looking at scan tool data
or following any factory trouble charts or actually
know what coolant temp is,your just assuming & not
doing the required testing to verify things

Nov 21, 2014 | Jeep Cars & Trucks

1 Answer

My AC is not working properly. Any ideas?

Check your blend door actuator. It is a very common issue. These links should be helpful: (video is for heater but it applies the same with A/C)

Apr 13, 2017 | 2004 Jeep Grand Cherokee

1 Answer

How do i reset climate control

There are a couple of options. Disconnect the battery, then drive the vehicle around without using the AC for 10 min, if the AC is defaulted to come on after a battery interuption, then shut the car down then turn it on again. You are trying to get the electronic actuator to reset and resume proper function. Another option is to try this: Start the car, adjust the pax side full hot, drivers full cold, wait 30 sec then shut car down, then start car back up and reverse the settings, pax full cold, drivers full hot. In both solutions, the vent actuators are stuck at either the full open or full closed, so you are trying to get it to 'self check' and allow them to resume proper function. After two years, I simply removed them altogether since I live where it is hot an only need just fine....

Nov 01, 2011 | 2008 Cadillac STS

1 Answer

I have a 2003 Jeep Grand Cherokee Limited with 4.7L, recently its been hot out and have runing my AC, it will run for about 10 mins then it would shut down, What you think it could be?

Are you saying your compressor is shutting down? Or your vehicle? If it is the AC pump I would get the unit charged because it sounds like it is low on freon.

If you are saying the vehicle shuts down, then we would need to know what all is affected before we could give you a WAG on that one.

Jul 22, 2011 | 2003 Jeep Grand Cherokee

2 Answers

If it's not an inconvenience, can anyone explain the process of removing and install a new one. I've been marooned for a week and my finals are coming up, so I'm truly desperate for some ez to explain...

Sorry, but this thread doen not include what you are wanting instructions on, please explain what do you need help with installing and removing.....

Oct 25, 2010 | 2001 Jeep Grand Cherokee

2 Answers

My hood on my jeep liberty will not complety shut? the only thing holding it down it the saftey latch.

Look at the hood alignment to make sure it's aligned properly and allowing the latch to catch. If the hood is fine you'll need to adjust the latch. Start by lubricating the latch mechanism so that it moves freely. Many times a hood will fail to latch properly because the latch itself isn't moving freely. Next check the area where the hood latches to the body and see if it's coming up short. If so manually adjust the latch until it's in proper position to grab and hold.

Mar 02, 2010 | 2005 Jeep Liberty

1 Answer

Air Conditioning

Check the system for vacuum leaks...All your controls under the dash are vacuum operated and may not work properly under power. Also, find out if the compressor is staying on when you don't have cooling. If there is an internal restriction it may be driving up the high side pressure and shutting the compressor down.Unless you have lots of specific a/c experience, I don't recommend you do much else.

Aug 09, 2009 | 2003 Jeep Wrangler

4 Answers

Heater/ac not working properly

Easy fix. The vacuum hose has come loose. Happens all the time. The hose is about 1/2" in diameter and can be found under the hood, in the middle of the engine compartment, on the drivers side. Just take a tie wrap and tighten it down over the plastic inlet.

Jan 05, 2009 | 2004 Jeep Grand Cherokee

3 Answers

93 Cherokee Heater/Blower/AC not working

Remove the insturment panel cover right behind the radio, remove the switch assembly look on the back right hand side there is a black plug connection (5 or 6 prong flat). this plug is and will always be a problem with jeeps. somtimes when a raido has been put in, the plug can be pushed away and there you go no heat, no fan. it could also be vibration from going down a rough trail.

Dec 11, 2008 | 1993 Jeep Cherokee Country

Not finding what you are looking for?
2003 Jeep Wrangler Logo

Related Topics:

67 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts


Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22359 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides