I have a 1995 Dodge Ram 1500 V6. When the A/C

https://manuals.co/workshop/dodge/ram/dodge-ram-1995-workshop-manual-1500-v6-3.9l/5526894. Heres a link it might help.

Click here to see.

3.9L V6 engine firing order is 1-6-5-4-3-2, cylinders on the pass side front to back are 2-4-6, cylinders on the driver side front to back are 1-3-5.

Note this information, about Dodge RAM 1500 have 3.9 engine... 1996 Dodge 1500 Pickup 3.9 liter V-6 VIN "X"




This is for one 3.8L V6 1996 Dodge 3.8 liter V-6 VIN "L"




Hope helps (remember rated this).

I would have the A/C compressor checked out.Also check for any leaks of Freon around the compressor area.

Assembly of converter to trans and then tunit to engine? The torque converter must engage and slide into the front pump. The seal is easily damamaged if not properly fitted.Once the trans is against the engine the converter can be slid forward to bolt the flex plste.There should not be more than approx. 1/4 inch between the converter and trans bell housing if the converter is properly mated to the trans. Good Luck, Ned.

ac has freon and is not cooling and the compressor is on

If it is 2 wheel drive, than it is a 238-2 tranny

- 42RE with the 3.9L V6
- 46RE with the 5.2L and 5.9L V8
- 47RE with the 8.0L V10 and 5.9L Cummins diesel

(238 is the cubic inch displacement of the 3.9L V6.)

it is advisable to check the high pressure side can try to Joanna water condenser with a hose and check the suction pressure and measure the temperature in the ducts through the A / C

if yu overcharged or it is low if the compressor was bad or if yu are freezing up yur condensor all of thiose would cause it