Question about 1997 Mitsubishi Montero

Open Question

Door locks opening and closing very fast when i open the car

Door locks opening and closing very fast when i open the door using key or fob

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hi my central locking will not open or close from my key fob


Check with your Ford garage if its a fob that contains a miniature battery that has died on you.

Jan 08, 2015 | 2008 Ford Focus 2.0

1 Answer

Hi, My 2013 Toyota RAV4 front passenger door lock is caught. It sounds like it locks/unlocks- but we can't get it open-seems caught. How can we fix this? We don't use keys, always have fobs in our poc


SO DOES THE METAL KEY WORK OR NOT?

If the electonics magic fails , this is first., right?

just passenger door?

so locks can jam, and can be very hard to fix.

object stuck there, (closing door with junk in hands)

also playing with latch, by kids can trip it into an illegal mode.

first get it closed, 100% is it.

then use the key, if that don\'t work it needs service.

the key is for emerancies, say baby stuck in car, so..... use it.

Dec 20, 2014 | 2013 Toyota RAV4

1 Answer

Sorry my car was not listed so picked Altima 2003 Micra Intelligent key fob not working properly. Can drive the car but cannot open or lock the doors. Did get fob wet. Now dried out. Worked for first few...


You are going to need to check the power lock control moduel on the inside of the door panel. If the FOB appears to be working but the doors are not unlocking, you need to check this. I would also replace all fuses that control the locks. If both of these devices check out ok, you may need to replace your FOB. To check your power lock control moduel, manually lock and unlock your doors by pressing the lock button on the inside of the door. If it does not work, it is either the fuses or the power lock control moduel. If it works, your FOB has gone bad. Hope this helps! Please rate 4 thumbs up!

Apr 18, 2011 | Nissan Altima Cars & Trucks

1 Answer

Doors do not centrally lock with fob or key (they close but open straight away). Onlu option is lock drivers side with key and then lock the other 3 doors manuually. Ford Fiesta Mark 6 in the UK


hi
you need to try a couple of diffrent things with this problem


1- get in drivers seat close doors and lock by hand
,
2- then put key in ignition and turn key till dash lights come on (do not start)

3- while key in ignition unlock doors with fob ,

4 - then lock again with fob while key in ignition.

5- then remove key exit car try locking doors from out side this should reset all your door locks

Oct 25, 2010 | Ford Fiesta Cars & Trucks

1 Answer

Remote key fob won'tprogram


1-insert and remove key from ignition two times

2-close and open driver door two times

3-insert and remove key once from ign.

4-close and open drvr door twice

5-insert key into ign.,then close driver door

6-turn key to on (not start) then off, twice this is rewrite mode,have all remotes to reprogram it will clear any lost remotes.

7-remove key from ignition,the door locks should cycle twice.if not start over.it may take a few tries.

8-press lock/unlock together and hold for a second

9-release,and press lock on remote,the door locks will cycle confirming program.continue to do other remotes you have,steps 8 and 9.if only one in possession,you are done. To end mode open door or insert key into ignition.

You'll need to follow the steps with no more than a 1-2 second delay between each step.. hope it works

Aug 13, 2009 | 1999 Ford Escort

1 Answer

1997 Porsche Carrera S --- Central Locking System Battery went dead while on travel and now the key fob for central locking is kaput! Is there a sequence to re-sync the fob to controller?


Hi,

Maybe you can try this procedure to resyn your key.
Initialization Procedure.

1. Open central locking system using the car key.
2. Get into the car and close all doors.
3. Using the car key, switch the ignition lock briefly to position "1" and then switch off again. (Please do this switching within 5 seconds or otherwise the system is not ready for initialization.
4. At the remote control key. Press the "OPEN" key (->) and keep holding.
5. When holding the "OPEN" key, press the "LOCK" button three time.
6. After pressing the "LOCK" button 3 times, release the "OPEN" button.
7. If the initialization process is sucessful, the door will lock and unlock immediately to confirm the process.

Jun 05, 2009 | 1997 Porsche 911

1 Answer

Door locks problem with one door drivers door


dont blame the idiot,we all make stupid mistakes without thinking and iam no exception,remove door trim and oil the solonoid with a oil can not a silly sunday mechanic spray and let it soak in as its working but i think its just a bit sticky with wear and dirt ingress hence it locks but doesnt unlock which might need a bit more power,oil the whole lot lock and all

Dec 05, 2008 | 2000 Renault 181

2 Answers

2004 Civic Drivers door lock


The driver's side door lock button is designed not to lock from the inside unless the handle is pulled, or the power switch is used. This serves as a reminder to not lock your keys inside.

If you are inside, and push down on the button (not the switch) hard enough to lock it, you've probably damaged it.

Jun 09, 2008 | 2004 Honda Civic

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

139 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...