Question about 1988 Mazda B2600 Cab Plus

1 Answer

WHEN DRIVING, ONE STOPS AT THE LIGHTS, IT REVS AS HIGH AS 2000RPM. WHY?

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 21 Answers

Idle set too high.

Posted on Sep 13, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Engine noise at 2000RPM


sounds like a transmission, try to shift it to neutral after you reach 2000 rpm + and see if the whining will stop

Jul 22, 2014 | 2007 Hyundai Getz 1.6

1 Answer

Hi,i have peugeot 407 2005,some time car start jerking while driving and start smoking if i stop car some where rpm meter continucly up and down and car realease black smoke but after switch it off and...


Hi I think you need to take car on a 20min long drive over 2000rpm try and keep revs high to clear filter. If that don't work you may need the fap filter changed hope this helps. Peter,

Dec 23, 2012 | 2005 Peugeot 407 2.0

1 Answer

When I start the car it stays at 2000rpm for a few moments then drops down. I'll drive for a few minutes then put it in park and it revs up and down.


idle air control valve is bad replace it. at start up choke control runs till warm up while driving throttle opening controls engine at idle ,the idle air control valve.

Aug 01, 2012 | 2005 Chevrolet Aveo

1 Answer

Hi, I have a 1985 toyota corolla ae82 engine and it has recently been in the garage for idle problems initially. I first took it in running rough and the machanic traced it to the auto choke which he...


if that 2000rpm is start up from cold,,,its still a bit high! but only a bit,,,should be nearer 1500rpm cold out of gear,,,,
when warm it should run at about 850---900rpm-----out of gear-
950rpm for an auto out of gear,,
in gear an auto will drop to about 850rpm so that the motor wont stall when holding the brakes down i would take the car back,, but they may wont it over night so they can set the revs up from cold,,i have a felling that auto choke is still playing up a bit

Aug 07, 2010 | Toyota Corolla Cars & Trucks

1 Answer

Focus 1.4 zetec idle tickover is about 2000rpm


sensor problem,without the right equipment it will be cheaper to put it in the dealers

Jul 09, 2009 | 2000 Ford Focus

1 Answer

2004 jeep grand cherokee idling problem. Revs motor 200 to 500 rpms higher while driving.


I had the exact same problem on my 04 GC. I put some Techron Concentrate Plus Fuel System Cleaner in from Wal-Mart and it seemed to fix the problems right away. Let me know.

May 31, 2009 | 2004 Jeep Grand Cherokee

1 Answer

After start-up, car revs high to 2000rpm for 2 secs, then levels.


might be a lazy idle air control motor, if it only does it on start up not a problem

May 25, 2009 | 2002 Toyota Camry

1 Answer

No Power at low revs 1HDT


these jeeps must be rubbish save yourself a couple of grand and get a new car like a landrover or a little car like a vw golf or a Cadillac

Jan 18, 2009 | 1996 Toyota Land Cruiser

2 Answers

High revs and surges when driving.


The revving to 2000 then dropping the 1500 likely means that it is in "limp home" mode. When there is a serious problem, the car will put itself in this limited mode to avoid further damage, and to get itself back home without stalling (hence the name). Since it stalls, its likely that there is a serious problem with the fuel system, and the limp home mode will not help you any more since you keep driving it like that. 
As far as the problem goes, it could be just about anything. Almost positive it has to do with the fuel system, but could be so many different things.
Hope this helps!

Jan 13, 2009 | 1993 Subaru Legacy

1 Answer

Fast idle


I have a similar problem which seems to stop ,if after 20 mins of driving or warmed up engine if you stop for 10 mins the revs die to a more normal 1500 revs! it is a spanish car now living in theUK I think the problem is choke related.

Oct 14, 2008 | 1988 Volkswagen Cabriolet

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

66 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8522 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...