Question about Isuzu Rodeo

1 Answer

ON MY 1994 ISUZU RODEO,#1,HOW CAN I TELL WHAT TRANNY IT HAS?#2,I HAVE NO REVEARSE AND FOWARD GEARS ,THE TRANY KICKS A SENSOR OFF WHEN I HIT AROUND 40MPH BUT SHUTING THE IGNITION OFF AND RESarting,IT WILL ENGAGE AGAIN. WOULD IT BE SOME SENSOR?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Mentor:

    An expert who has written 3 tips or uploaded 2 video tips.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 102 Answers

Un plug trany sensor

Posted on Sep 13, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What turns the speed sensor in tranny 2004 isuzu.rodeo 3.5 Can it be repaired without replacing the transmision?


it is driven by a drive gear on the output shaft of the transmission. you could have a bad driven gear that is the gear that is driven to create the electrical pulses to show a speed. the drive gear on some transmissions are part of the output shaft and some gears are replaceable without replacing the output shaft. in either case a part can be replaced without replacing the complete transmission.

Sep 29, 2014 | 2004 Isuzu Rodeo

1 Answer

It idles but when put in gear it goes dead


spark plugs, a tune up is not 1 filters.

read the 60k, service points list? bingo.

sounds like you have no engine power. (not tranny slip)]

if rpm goes high and you dont move, the tranny is slipping.

causes?

of low engine power are 50 , reasons.

but top 2.

never did the 60k. (tune up)]

low fuel pressure for any reasons.

tell engine size, lots of sizes, cant guess that or what to do next

Aug 20, 2014 | 2000 Isuzu Rodeo

1 Answer

94 Isuzu Rodeo 3.2L V-6, automatic transmission slips from first to second


guesses? there are over 10.

1; low level or too high ATF.
2: filter packed. do the service now.
3: low pump pressure.
4: bad clutch packs, if it slips now, it will get worse faster.
5: or any of the other vast ways to get the wrong pressure to the servos. (huge list)
the fsm covers on car check for a/T why not read that.?
every step.

Apr 13, 2014 | 1994 Isuzu Rodeo

1 Answer

Where is my tranny fluid.....no more clutch


if you do not have a clutch, you need a new clutch. Adding more gear oil to the manual gear box will not restore a clutch. It is a 94 and anything past 10 years on a transmission is good.

Nov 18, 2010 | 1994 Isuzu Rodeo

1 Answer

Where is MAF sensor on 1994 isuzu rodeo Runs rough


The sensor should be right there where the intake air duct meets the air filter housing.
That oil down in the spark plug tube is most likely from a leaking valve gover gasket. Oil in there can and will cause misfires.

Oct 07, 2010 | 1994 Isuzu Rodeo

1 Answer

Not getting any fire in 94 isuzu rodeo


SWITCH ASM; POWER,IGN COIL 8-94474-294-2 Go to myisuzuparts.com and find this part number. This part is under the intake manifold. No crank sensor as is has a distributor. 8-94474-294-2 1 05-1990 to 08-1994




Feb 22, 2010 | 1994 Isuzu Rodeo

1 Answer

1998 Isuzu Rodeo 2WD.My speedometer / odometer has quit working.


You need to replace the speedometer gear that drives the sensor.

Dec 07, 2009 | 2000 Isuzu Rodeo

1 Answer

Ignition switch want turn off


Pull shifter all the way back and push it foward to park firmly. Try to get key out now. The cable needs to be adjusted.

Aug 02, 2009 | 2000 Isuzu Rodeo

1 Answer

1st gear slipping at start. reverse and other gears fine. shifts between gears fine. if i start off slow it wont slip. 01 rodeo 4 cyl. also eng light has been on for 1 yr. has 120000 miles.


Have you checked the trani fluid ?
It could be slipping just enough to notice in 1st gear beause that is the most resistance..
A slip is a slip..
Or it could be that the bands are warn in only first gear - wich would cause damage before long..
Some shops give free estimates..

Jul 22, 2009 | 2001 Isuzu Rodeo

1 Answer

Want to get it right the first time..


try checking the fluid level in the gearbox,rodeo dont have a dipstick so u have to undo the plug on the side of the gearbox just like a manual gearbox.if the oil is really low i suggest doing a full service on the gearbox,change the oil and filter is ideal for better results.

Jun 16, 2008 | 2001 Isuzu Rodeo

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

70 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...