Question about 1992 Subaru Loyale

1 Answer

Can you use an after market fuel pump? - 1992 Subaru Loyale

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 784 Answers

Absolutely, as long as it fits with current connections, meaning you don't have to modify at all. I use it all the time.

Posted on Sep 13, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

Why does my fuel pump relay fuse keep blowing on my Volvo 2005 S40

use a meter and test the connections ,lines ,pump for damage or short

Nov 18, 2016 | 2005 Volvo S40

1 Answer

Fuel pump

This could be the fuel pump relay. There is also what they call a fuel sending relay. I believe you would always show empty even though you have gas. Lastly those after market pumps can sometimes be bad right off the shelf! I would check the relay first.

Apr 23, 2013 | 1997 Mercury Sable

2 Answers

I have a 1984 454, the push rod for the mechanical fuel pump is not moving.How can I fix it.

If the fuel pump rod is not stuck, and it does not move up and down when the engine is turned over, then most likely the camshaft would have to be replaced to restore the mechanical fuel pump function. The problem is that the fuel pump rod is ran off of an eccentric lobe on the camshaft itself, and that lobe has worn down until it is almost completely round and has no more lobe or "lift" to move the fuel pump rod, so the fuel pump rod will just sit there and barely move at all.

The quickest and the cheapest way to get that vehicle back on the road without having to replace the camshaft is to simply remove the fuel pump rod, and then purchase a block-off plate for the opening where the mechanical fuel pump used to be, or just replace the mechanical fuel pump and let it do nothing but seal off that opening, and then install an after-market electric fuel pump, and since that engine should have a carburetor if it had a mechanical fuel pump (either that or it had a low pressure throttle body injection system that does not require a lot of fuel pressure), then an after-market electric fuel pump for that engine will not be that expensive, and usually less than half the price of an electric fuel pump that would be needed to run a fuel injection setup. Let me know if you require any further assistance or any assistance with connecting an after-market electric fuel pump.

Jun 18, 2010 | 1984 Chevrolet Chevy

1 Answer

Fuel pump replacement

no you don't replace the tank you just pull it out to replace the pump which is in the fuel tank. here is the part number for a new fuel pump module
MOTORCRAFT Part # PFS43 Truck built in Mexico for US market $328.00.
Truck Built in USA part number is PFS342 $323.00

Jan 19, 2010 | 1996 Ford Explorer

1 Answer

Diesel engine, grey market kubota, the turqouise

yes there is a low pressure pump and a high pressure(incjector pump) if your no getting fuel to engine check for low pressure pump to be working may also have air in system which is very hard to get out and a diesel wont run untill most or all air is gone

Sep 05, 2009 | 1984 Dodge Caravan

2 Answers

My fuel pump is not working but ther is power going to the pump and i just replaced the pump and relay

hope you used oe typ pump to many isuses with after market pumps so any way if you have power at pump what is voltage needs to be 12v at least pull hose see if you have fule coming out power the pump your self now if you got after market pump did you replace the pig taile with supled updated one should ben in box .if not need put new pig tail on hope this helps

Aug 13, 2009 | 1996 GMC Sierra

2 Answers

1994 S10 Blazer Fuel Issues?

are you sure the pump you installed is not defective it does happen more than you can believe. If you can run a power to the pump hot line or jump the relay and have a ear to hear if it is pumping, this is what I would suggest.. Good luck

Jun 23, 2009 | 1994 Chevrolet S-10 Blazer

Not finding what you are looking for?
1992 Subaru Loyale Logo

Related Topics:

30 people viewed this question

Ask a Question

Usually answered in minutes!

Top Subaru Experts


Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8522 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides