Question about 2003 Chrysler PT Cruiser

Open Question

The drivers side amber running/turn signal light is burned out. How do I replace it?

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Why would only one out of 4 marker lights work?


you are right all marker lights come off of one fuse, inside instrument panel, number 29, a 10 amp fuse my manual does not give a lamp number, it has a chart, head lamps (high) lamp 9005 60 w type a, headlamp (low) 9006 51 w type b, front marker lamps 5w type d, for the rear it says to use a lamp 7443 21.5 w type d, I do not use these, I have special lights on mine, hope that it helps

Mar 28, 2015 | 2007 Scion tC

1 Answer

1997 ford crown vic lx.Both directionals work, Hi+lo beam work,but amber driving light on driver side does not. passenger side ok.3157 bulb runs driving and turn signals. I checked the 2 bulb harness with...


Is the bulb holder rusty , it sounds like a bad earth. With a volt meter probe the bulb holder earth to the power terminal should be battery voltage. if not probe power terminal to metal part of body should be battery voltage if not fault in wiring.

Oct 16, 2014 | Cars & Trucks

1 Answer

How do I change the front side marker light bulbs?


Bi-Xenons - 6000K D1S
High Beams - Osram Nightbreakers H7
Fogs - PIAA H11 Yellow Ion
Cornering Lights - Osram Nightbreakers H3
Front Park Lights - High-Powered LEDs with built-in resistors
Front Signal Lights - Sylvania Silverstar 7507A ST (Silver Bluish but lights up Amber)
Front Sidemarkers - InviSilver W5W (Silver but lights up Amber)
Rear Signal Lights - P21W Stealth Bulbs (Silver but lights up Amber)
Reverse Lights - Sylvania Silverstar 7506ST or Error-Free LEDs
License Plate Lights - C5W Error-Free High-Powered LEDs
  • Turn the engine off and approach the side of the porsch with the burn-out side-marker light. If you are replacing both, start at either side; the replacement procedure is the same.
  • 2 Remove the screws from the plastic fender liner. Peel back the liner to access the area behind the fender.
  • 3 Reach your hand inside to gain access to the side-marker light's backing. Push the backing forward to release the side-marker lens; it's held in place by small clips.
  • 4 Grab the lens on the outer side and turn it over to access the back. Gently turn the bulb to release it from the plastic lens.
  • 5 Pull the bulb straight out to remove it from the electrical socket. Insert a new bulb, but do not touch the glass part of the bulb with your hand.
  • 6 Push the new bulb into the side-marker lens. Turn it clockwise to install it. Push the side-marker lens back into place. Apply gentle pressure to the lens to pop it back into its mount.
  • 7 Replace the screws along the edge of the fender liner.


  • Dec 04, 2010 | 2006 Porsche Cayenne

    1 Answer

    Ok, had a trailer wire box attached to rear drivers side-wife left it hanging out and ran over it. Now I have no rear driver tail light or front amber running light. All turn signals and running lights...


    check all your fuses. something may have shorted out and blew out a fuse.if you don`t have blown fuse there is a short somewere.you will have to locate it.

    Nov 26, 2010 | 1994 Jeep Cherokee

    2 Answers

    How do I fix my left blinker? light still works but it sticks instead of blinks


    What you speak of as to the left blinker doesn't flash, yet the instrument cluster shows the green arrow (to the left), and yet that and the left turn signal lights do not flash, appears to be a simple burned out bulb. If one of your left turn signal bulbs are burnt out, then the #552 Flasher Unit in your fuse box is NOT the cause. It's the "Amperage" not being correct to the flasher unit. Place the parking brake on and start your vehicle. Put the left turn signal on and check to see ALL the bulbs are illuminated for the left turn signal. If you find one bulb that is not illuminated, then replace the bulb. It should be an 1157 bulb, but in the front it could be a 1157 Amber bulb dependent on whether your turn signal lens is clear or yellow.

    If you still have difficulty finding the dead bulb, turn on the right turn signal and see which bulbs are illuminated and this will give you an idea as to which bulb on the left side isn't working, or turn on your Emergency Flashers which will turn on both the left and right side lamps and see which bulb is not lit up.

    I hope this Helps,

    ~00 Buck~

    "Still living on the Right Side of Dirt..."

    May 24, 2010 | 1972 Oldsmobile 98

    1 Answer

    Turn lights don't blink


    If the turn signals don't blink on both sides of the car, the culprit is the flasher, a small box usually located under the dash on the driver's side. Replace it with a new part.

    If the turn signals don't blink on only one side, one of the bulbs on that side is burned out. Turn on the turn signal for that side and visually inspect the turn signals. Replace the burned-out bulb.

    May 15, 2010 | 1999 Plymouth Breeze

    1 Answer

    Had a problem with a right, amber side marker on right side


    Usually one of the holes in the marker light where screw goes in, has metal contact where screw meets light, but if not, and they are not push in wire connection type from behind, then just run your white wire up through hole in housing, and bare the end & tighten it up under screw holding light to body. White should be ground, brown should be power.

    Jul 02, 2009 | 2004 Dodge Ram 2500

    1 Answer

    Right side of trailer running lights does not work


    Usually one of the holes in the marker light where screw goes in, has metal contact where screw meets light, but if not, and they are not push in wire connection type from behind, then just run your white wire up through hole in housing, and bare the end & tighten it up under screw holding light to body. White should be ground, brown should be power.

    Jul 02, 2009 | 2004 Dodge Ram 2500

    Not finding what you are looking for?
    2003 Chrysler PT Cruiser Logo

    Related Topics:

    33 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Chrysler Experts

    yadayada
    yadayada

    Level 3 Expert

    76649 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22219 Answers

    Jeff Turcotte
    Jeff Turcotte

    Level 3 Expert

    8522 Answers

    Are you a Chrysler Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...