Question about Porsche 944

1 Answer

1983 Porsche 944 coil goes bad, just replace coil

1983 Porsche 944 coil goes bad, just replace coil and ran great then 4 days later coil is bad again. What would caue the coil to go bad

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Porsche Master
  • 4,336 Answers

What do you mean by bad? Does it measure a different resistance.

Here is the thing on coils, I do not understand why they are not made differently, but

coils are to be run at a lower voltage, often. some like older cars, no more than 8 volts....Think about it...That is a LOT of resistance to scrub down to 8 volts, hello? the system is 13.8 to 14.9 volts NORMAL.....

But I digress.

These resistors fail and the amount that they should do, they cannot do.
One thing that I do as a diagnostic test is to buy a coil, any coil with an INTERNAL resistor. So, I can put full sysytem voltage to it....If it lasts, investigate the viotage available at the coil.

Doc

Posted on Sep 13, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

83 porsche 944 wont start replaced coil pulse sensor fuel pump relay...get power to coil but not from coil


Did yo check where it comes out of the coil or the other end of the wire that comes from the coil wire could be bad if you have an ohm meter connect it to wire only and see if there is high resistance in the wire

Dec 28, 2012 | 1983 Porsche 944

1 Answer

I have a 1983 944 Porsche. No Spark!!!


Contact you local dealer for help with repair connectors, they do make most of them.

Aug 24, 2012 | 1983 Porsche 944

1 Answer

I have a 1983 Porsche 944 that I just purchased. It had a bad miss when I got it. I have replaced the coil, plugs, plug wires, dist cap etc. I have now found that if I unplug the cam shaft sensor, it will...


hi rough running or not firing on all cylinders try tapping the injectors with a spanner a i had the same problem and it was asticky injector put inj cleaner inn fuel tank for nxt 3 fill ups no more problems

Nov 07, 2010 | 1983 Porsche 944

1 Answer

Electrical intermittant problem porsche 944 1983


Have you checked for good grounds? Sometimes water or wetness will help with conductivity. Grounds are all over the place and are usually corroded, braking the bond. Make sure that all grounds are clean and secure.

Mar 18, 2009 | 1984 Porsche 944

1 Answer

Vibration at 3 thousand rpms ?


I would Check/Replace the Transmission Mounts. That would be the Only Reason that the Shifter would Vibrate this Bad. Please Rate My Response! Thanks!

Feb 01, 2009 | 1983 Porsche 944

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

169 people viewed this question

Ask a Question

Usually answered in minutes!

Top Porsche Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

881 Answers

yadayada
yadayada

Level 3 Expert

75822 Answers

Are you a Porsche Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...