Question about 1999 Dodge Intrepid

2 Answers

A/c blower my a/c blower only wants to blow on hi speed all other speeds dont wk.

Posted by on

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 436 Answers

Beside the heater blower motor is a module bolted to the heater assembly. this module is called a resister, This is the device that limits power to the motor and is what controls heater speeds. simply replace this module and you should have speeds back. while changing the module make sure the connector is not melted or burnt. if it is, you will have to change it also.

Posted on Sep 12, 2009

Testimonial: "very good advice"

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 811 Answers

Replace fan control switch

Posted on Sep 12, 2009

Testimonial: "very helpful start"

  • chris quammen Sep 12, 2009

    replace fan control switch

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ford windstar. Speed control problem on rear blower. It only works on high speed (4).


possible bad switch... possible loose wires to the switch and or motor...

Feb 11, 2014 | 2000 Ford Windstar

1 Answer

My 2005 nissan almera 1600 blower motor blows a fuse


Dont use speed 4 untill you have had the speed resistor in fan replaced or repaired

Nov 17, 2012 | Cars & Trucks

2 Answers

I have a 1979 oldsmobile delta88 for several years.My blower motor stays on and blows at a constant low speed and doesnt blow much on high.I already replaced sll components except for thewhole a/c switch...


REPLACE BLOWER MOTOR RESISTOR. IF YOU GET ONLY ONE CONTROL SPEED.IF YOU HAVE ALREADY REPLACE BLOWER MOTOR RESISTOR.BLOWER MOTOR CONTROL SWITCH BAD. REASON BLOWER STAY ON ALL THE TIME.FAN BLOWER MOTOR RELAY BAD.
.

Aug 25, 2011 | Oldsmobile Delta 88 Cars & Trucks

1 Answer

Ok, may sound like a dumb question,but how do you know if its a blower motor resistor problem or just the blower/motor. Ive been reading solutions for problem on the A/C blower still blowing air but speeds...


The blower motor resistor is usually only switched into the circuit for the lower speeds and for the fastest speed the resistor is bypassed so I guess the motor needs to be replaced if it does not work in any position. However, sometimes the blower motor is not protected by a fuse but by an automatically resetting sealed circuit breaker usually located not far from the motor. The circuit breakers dont fail very often, If the fan works for a few seconds and then stops and then does the same thing several minutes later then the fan motor definitely needs replacing.

Aug 21, 2010 | 2006 Nissan Altima

1 Answer

The airconditioner only works in my 2006 H3 when the car is physically moving over 25 mph. If it is going slow or idling there is no air coming from the blower/fan. When it does blow it is only on a low...


There is a HVAC relay and FUSE in the under hood fuse box, have you check both of these? If the blower works on any speed, the blower is good. You say it blows on lowest speed? The blower speed resistor is mounted on the blower housing. The HIGH SPEED BLOWER RELAY is mounted on the blower motor. You may have multiple problems but check fuses first, if all is OK, then a qualified repair shop will need to check further. You do NOT need the whole A/C system replaced. If it does blow cold, thats good, you just need the blower working.

Nov 03, 2009 | 2006 Hummer H3

1 Answer

Blower quit


Blower motor is likely bad if it doesn't work on any speed, if it works on only one speed then there is a resistor located by the blower motor that is bad each item should run around $30 at local parts store

Nov 17, 2008 | 1996 Jeep Grand Cherokee

4 Answers

1998 GMC Sierra pickup truck cabin fan problem


Your blower moter is under your glovebox and very easy to replace.I dont think thats your ploblem.I would pull off the dash.It will snap right off without breaking anything.Then pull out the part that holds the selector switch for the fan speed.Then you unplug that switch.Clean the copper contacts.Plug it back in.If everything works again like it should and did in my truck then it is either that switch that is bad or the wiring harness.I would replace that switch.

Oct 20, 2008 | 1998 GMC Sierra

1 Answer

2000 Pontiac Grand Prix interior fan speeds 1-4 not working


Check the ground, the resistors are accully resisnting the Negitive Current.

Jul 28, 2008 | 2002 Pontiac Grand Prix

Not finding what you are looking for?
1999 Dodge Intrepid Logo

227 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6918 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...