Question about 2003 Chevrolet Corvette

1 Answer

How do i remove the foglight bulb off a 2003 chevrolet corvette

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 66 Answers

Drop the splash shield, the sockets should twist counter clockwise, and pull out

Posted on Sep 12, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Turn signal bulb replacement on a corvette z06 20003


Think last time I did one of them I went in thru ram air intake near light...not sure on yr/model...but I managed to get a new one installed that way after wasting 20 min going other routes

Sep 24, 2014 | 2003 Chevrolet Corvette

1 Answer

Renault scenic front foglight bulb


I found the easiest way to change the fog light bulb is to take bumper off, takes 5 mins, 5/6 screws/clips across the top were the bonnet meets the bumper and a few clips on wheel arches then pull off and 2 spot lights very easy to Accra.

Mar 31, 2012 | 2003 Renault Renault Scenic 1.6

1 Answer

How to install f55 rear shocks on my 2003 corvette


Disconnect the wiring, unbolt the shocks, remove tie rod nut and remove tie rod from control arm, remove and replace the shocks and reconnect the wiring.

May 19, 2010 | 2003 Chevrolet Corvette

1 Answer

How to change 2005 Corvette fog light bulb


Fog lights are simple, but tight as you would expect.

You will need to jack up the front.

Remove the front fascia closeout panel and right and left lower cowl/spoiler.

Un plug the electrical to the back of the foglight, reach up in and unscrew the bulb. A bit tight. It is about a half or three quarter turn. Pull the old bulbs out.

Install in reverse.

You may need to adjust the beam if you tug to much.

Once you remove the access panel and then pull the brake cooling duct out of the way (just snaps in place...).

It was not necessary to remove the small air-dam corners on my car (nor is it specified in the service manual), but it it make the job easier, it is only two or three screws per side.

Thank you for suing fixya and be safe

Apr 18, 2010 | 2005 Chevrolet Corvette

1 Answer

How do i replease the fog lights on my 2003


To replace the foglights, you need to get at them from the backside, under the car. The best way is to jack the car up to give yourself some room.

It is very easy to replace and you can replace JUST the bulb. Don't have anyone tell you you have to replace the entire assembly.

Removal & Installation
  1. Disconnect the negative battery cable.
  2. Detach the connector for the foglamp.
  3. Twist the foglamp bulb 1/4 of a turn and remove the bulb from the foglamp lens.
To install:
  1. Twist the bulb until the tangs engage into the foglamp lens.
  2. Attach the connector for the foglamp.
  3. Connect the negative battery cable.

Feb 13, 2010 | 2003 Pontiac Sunfire

1 Answer

Verona 2005 fog lights won't work. Fuses are ok, lightbulbs are ok. Fog light switch lites.


Remove the entire foglight assembly check for a loose wire inside the assembly. I had the same problem on mine but it only affected one of the foglights. Also check with a test light at the connector where it connects into the foglight assembly. Also make sure foglight bulbs are properlly tighted.

Dec 08, 2009 | 2005 Suzuki Verona EX

1 Answer

HOW DO I INSTALL UNDERHOOD LIGHT ON 1998 CORVETTE


assuming you mean replacing the bulb? about $2.00 a bulb
the bulb is push and twist, open the hood and remove the plastic cover then remove the bulb by pushing it down and twist it a little till it pops out. I see only one light , I think my 1994 vette has two
photo
hope this helps
Eric

Aug 25, 2009 | 1998 Chevrolet Corvette

1 Answer

Is there a small light around the ignition switch-2003 C5 Corvett


no it i on the same fuse as the other lites, there is tiny tiny bulb, it is burned out.

Aug 12, 2009 | 2003 Chevrolet Corvette

1 Answer

How do i change rear turn signal bulb on 89 corvette, notmine???


Rear Turn Signal, Brake and Parking Lights 1984–89 VEHICLES
  1. If removing an inner bulb, remove the license plate. For outer bulb replacement, reach from under the vehicle.
  2. To remove the inner rear brake light, you must reach behind the license place and under the vehicle to access the bulb and socket
  3. Remove the socket from the lens by releasing the locking tab and twisting
  4. Once the bulb and socket are pulled from the rear of the lens, grasp it from behind the license plate opening
  5. Then, pull it out of the side and replace the bulb
  6. Remove the bulb from the socket and replace.
  7. Installation is the reverse of the removal procedure.

Apr 05, 2009 | 1989 Chevrolet Corvette

Not finding what you are looking for?
2003 Chevrolet Corvette Logo

Related Topics:

95 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...