Question about 2003 Ford Explorer

1 Answer

ENGINE DOES NOT CRANK , JUST CLICKS, HAS A BRAND NEW BATTERY, ?

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 3 Answers

Starter could be bad or the cylinoid on the firewall.

Posted on Sep 12, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

The car will not crank starter brand new battery good turning the ignition the starter will click


is the engine siezed ?? try another battery from a known car that starts ,a battery can show 12.4 or more on the meter but have no reserve amp capacity to make it it crank ,this i get on modern batteries owing to the fact their sealed unit so you cannot check the water level in them ,,,,use a hammer and chisel and break the sealed for life top off and you will see what i mean

Jan 03, 2016 | Cars & Trucks

2 Answers

Why ent there enough power going to my brand new starter motor seems to spin slow when i connect strait from battery


hook a volt meter up to your battery you should see around 12.5 volts. Then crank the engine and see what the voltage drops to. If it drops to less than 12 volts the battery is bad.

Sep 16, 2015 | Cars & Trucks

1 Answer

My 1995 GMC YUKON 5.7L 350 engine will not crank/turn over..Battery, starter, fuel pump and alternator are all brand new because of this issue but the problem still persist. I'm lost on what other...


try and turn engine by hand to make it is not seized .if ok it may have a bad electoral connection either from battery to starter or from battery to engine earth, voltage drop can be checked with a volt meter.

May 11, 2014 | Cars & Trucks

1 Answer

Car won't start, has brand new battery, but when I try to turn it over it just clicks and if I hold it down it makes a buzzing noise. Other than the starter, what else could it be?


That is a sign of a bad or weak battery. It is not getting enough juice to crank engine. Have you tried jump start. If it does jump start, the battery is bad

Aug 16, 2013 | 2000 Mitsubishi Galant

1 Answer

1998 Honda Accord Won't Start


Park neutral safety switch maybe be the reason for the no crank ! Try putting the vehicle in park ,then try to crank the engine . Testing the electrical circuit is the best way to trouble shoot this problem , along with do a voltage drop test on the starter circuit ! This will test the battery cables an connections .
Starter Voltage Drop
How to voltage drop test starter motor circuit
Does it have a manual or automatic transmission ? Manual ? clutch switch . Looking at a wiring diagram I also see a starter cut relay !
http://www.bbbind.com/free_tsb.html Free wiring diagrams . Enter vehicle info. year , make , model and engine size . Under system click engine , under subsystem click starting . Then click the search button , then click the blue link ! Check the starter cut relay also . Videos on youtube showing how to test a relay controlled circuit !

May 29, 2017 | 1998 Honda Accord

2 Answers

New battery and new starter but still will not crank only clicks


More than likely the charging system is not working and allowing the battery to run down/low. Put a voltmeter on the battery and raise the engine about 2000 rpm and the battery should read 13.5-15.5 volts with all electronics on (fans switch on high, flashers, wipers, headllights, defrost etc). It should also read about 13.5 volts at idle but may not depending on the load from the accessories and voltage regulator. Most important is that it will read 13.5-15.5 volts when the engine is at 2000 rpm with the accessories on. If it does not read in that range the charging system(alternator most likely) has a charging problem.

Nov 15, 2012 | 2000 Chrysler LHS

1 Answer

1998 Ford Ranger won't start.


Check the igntion signal to the starter solenoid.

Oct 10, 2012 | 1998 Ford Ranger

1 Answer

Brand new battery with 850 cold cranking amps.....lights and radio work fine...try to start the engine and it clicks...click is on the passenger side by what I think is the A/c unit


That would be your starter solenoid clicking, the positive battery cable runs off the battery to it, easy way to track it down, you can test it by putting your ignition key in the on position and using a jumper wire connect the two large terminals, if the car starts replace the starter solenoid, if it doesn't do anything replace the starter.

Jan 25, 2011 | 1992 Ford Crown Victoria

1 Answer

Engine just clicks when cranked. battery is brand new. where is the starter??


Sounds like a classic ground problem for sure.
Make sure the battery terminals are really clean,try vinigar to clean them.
Bet it starts,if not check the solinoid somewhere mounted on the fender or firewall.

Nov 24, 2010 | 1995 Ford Econoline

1 Answer

What battery should be used in the car?


It depends on which brand of car battery you prefer. You will get a range of different opinions on which brands are the best based on experiences with different brands.
If you are happy with the Exide brand then the battery selection depends upon which engine you have fitted in the car - the 2.2 litre or 2.4 litre. Anyhow here are some Exide models that will fit your vehicle. You need an Exide 75 size/model with the correct minimum CCA (cold cranking amps)

2.4 Litre engine - Exide 75 - 600 cold cranking amps

2.2 litre engine - Exide 75 - 525 cold cranking amps

Any large battery retailer will be able to help you select a battery suitabe for your car but many specialise in particular brands. Personally I prefer to select a heavy duty battery that is suitable for the vehicle and will offer more than the minimum required cranking amps.

Dec 06, 2009 | 2000 Pontiac Sunfire

Not finding what you are looking for?
2003 Ford Explorer Logo

Related Topics:

77 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...