Question about 1999 Chevrolet K1500

1 Answer

99 suburban 5.7 1500 location of camshaft sensor

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 66 Answers

If it has a distributor (most chevy v8's did in 99) it is located within the ignition module, the pickup coil is there as well as a reluctor or (star) wheel that signals spark and injector pulse

Posted on Sep 12, 2009

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 462 Answers

SOURCE: 99 suburban 5.7 1500 location of camshaft sensor

It's in the distributor. There is 2 connectors on the outside of the distributor to it. Make sure they are both connected before replacing parts. The gear on the distributor wears out too.

Posted on Sep 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the camshaft position sensor located in a


The camshaft position sensor is located on top of the engine near the ignition coils.
The camshaft position sensor is located on top of the engine near the ignition coils.
The camshaft position sensor is located on the engine near the timing belt cover and under the upper radiator hose.
The camshaft position sensor is either located near the top of the engine, passenger-s side, or on the right side of the engine near the ignition coils.
The camshaft position sensor is located on the engine near the camshaft pulley.
This sensor is located at the front of the engine near the camshaft gear this is what I got 6 different locations manual covers 99-05

Oct 10, 2014 | Cars & Trucks

2 Answers

99 GMC suburban 5.7l P1345 wont start/misfire


The primary intent of this code is to detect slipped camshaft timing. Have you checked the camshaft timing? Your symptoms indicate you are a tooth off.

May 24, 2017 | 1999 GMC Suburban

2 Answers

Where is the cam shaft location sensor located on a 2005 gmc yukon


camshaft sensor located above crankshaft pulley, the camshaft sensor mounted on the front timing cover above the crankshaft pulley.

Sep 17, 2012 | 2005 GMC Yukon

1 Answer

Location for crankshaft and camshaft sensors on a 1999 GMC Suburban, and the probability of either going bad? The vehicle would start and run, then die. It was fine the day before, but with each time of...


The camshaft sensor is in the distributor, beneath the ignition rotor. The crankshaft sensor is inserted into the passenger side bottom of the timing chain cover. I personally have not seen either of these compnoents cause this type of problem. You probably should take this vehicle to a shop and have them do a diagnostic on it.

Sep 05, 2011 | 1999 GMC Suburban

1 Answer

Were is cam sensor for 99 suburban?


kittle6298_3.jpgHere is a picture of where it is down next to your camshaft pully

Apr 29, 2011 | 1999 Chevrolet Suburban

1 Answer

Where is the cam position sensor located on a 99 oldsmobile alero, how easy is it to install?


camshaft position sensor location on the V6 engine located at the front of the engine block below the power steering pump. the 4 cylinder engine camshaft position sensor location below ignition coil cover where coil cover say 2.4L TWIN camshaft sensor in that location below coil cover. you will see red or red white wires connected to it.

Apr 14, 2011 | 1999 Oldsmobile Alero

1 Answer

Where is the camshaft sensor located on my 99 Jeep Grand Cherokee


If you still have a cap rotor and ignition wires, it's inside the distributor. If not, it is the part where the distributor used to be (center rear of the engine behind the intake manifold)

Feb 19, 2010 | 1999 Jeep Cherokee

2 Answers

99 suburban 5.7 1500 location of camshaft sensor


It's in the distributor. There is 2 connectors on the outside of the distributor to it. Make sure they are both connected before replacing parts. The gear on the distributor wears out too.

Sep 12, 2009 | 1999 Chevrolet Suburban

Not finding what you are looking for?
1999 Chevrolet K1500 Logo

Related Topics:

613 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

80407 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...