- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The expansion valve is located within the passenger compartment, driver's side. You need to remove a white plastic piece, called a pipe cover. Once that is out the way, the expansion valve is hidden behind the large, rubber covers. Cut the zip ties to get to it.
Well believe it or not, your car is one of the few cars that have adj valves. The specs are written on the cam gears, and it is a fairly easy job. If your car hesitates, or rattles, it might be time for the adj. Hope this helps.
Hi,welcome to fix ya.
there is a motor under the dash on the passenger side called the "air mix motor" by acura that goes out on these and causes this it is just under the carpet under the radio .you can reach it from the passenger side . change this and you adjustment will return
You need to replace your IAC (idle air control valve). The IAC, like it sounds, control the idle of your car. When they go bad they will cause the low idle and stalling. The IAC is located on the throttle body and is usually held on with a couple of screws. It is an easy relatively cheap fix that you can take care of by yourself. Let me know if you have any more questions. Thanks for rating my response and for using FixYa!
I'm, thinking you may mean cam rocker arms (lobe followers) and like the saying goes, "1 picture is worth a thousand words". These arms fit below cam shaft and sit over valve springs with a small round disc shaped spacer. These spacers are notched so the follower rest on valve. The other end of follower sits atop of the lash adjuster, The top of this adjuster is globed shaped to fit securely to the follower while allowing the correct lash adjustment by two hex nuts on the adjuster.
Confused yet? Well its not easier said than done. If you have access to a shop manual hopefully picture will help Good luck and I hope I have helped. Kam