Question about 2005 Chrysler PT Cruiser

Open Question

Motor runs but you have to help phsicaly to raise and lower top on 05 pt cruiser

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the ECM located?


How To Change The PCM On A Chrysler PT Cruiser ...

? 14:05
https://www.youtube.com/watch?v=fLN48sAKpiE
Jul 24, 2014 - Uploaded by The Hapless Housewife
How To Change The PCM On A Chrysler PT Cruiser ... things wrong with my car now, but had I replaced the PCM (aka) ECM a long time ago, ...

Chrysler PT Cruiser Engine Computer Module ECM PCM ...

www.ebay.com > ... > Engine Computers

eBay
$169.00 - ‎In stock
Chrysler PT CRUISER Engine Computer Module ECM PCM ECU - "Plug & Play" in eBay Motors, Parts & Accessories, Car & Truck Parts ' eBay.

Chrysler PT Cruiser Engine Computer



Dec 30, 2015 | 2002 Chrysler PT Cruiser

1 Answer

Pt cruiser shakes at acceperation


Have the CV Joints checked for excessive play.

Jul 15, 2017 | 2002 Chrysler PT Cruiser

1 Answer

Timing alignment marks


Timming for 2.4 avenger

Jan 14, 2014 | 2009 Chrysler PT Cruiser

1 Answer

I put a 2005 motor in a 2001 pt cruiser and put all the 01 sensors on the 05 motor except for the crankshaft senor it is the 05. I am not getting fire at the coil pak


your crank sensor IS what fires the coil pack
mixing the two years sounds like the problem
check wire harnes see if the 01 powers the 05 the same termail
01 senor and pack may have to go back
good luck!

Mar 01, 2012 | 2004 Chrysler PT Cruiser

2 Answers

Where is crank sensor on 2005 PT Cruiser? It absolutely is not above the oil filter as on 01-03 PT's.


REMOVAL - 2.0, 2.4, 2.4L TURBO
The Crankshaft Position Sensor is in the front of the engine block just under the starter motor (CRANKSHAFT POSITION SENSOR LOCATION).

Disconnect the negative battery cable.
Raise vehicle and support.
On 2.4L SRT-4 remove the lower inner cooler hose from the metal tube.
Remove the Structural Collar (Structural Collar and Bending Strut-(Automatic Transaxle Equipped) ), refer to the Engine, Structural Collar Removal and Installation section.
Unlock and disconnect the electrical connector to the crankshaft position sensor.
Remove the crankshaft position sensor bolt.
Remove the sensor. Arrow points to sensor in picture.


emissionwiz_108.gif

Aug 22, 2011 | 2005 Chrysler PT Cruiser

1 Answer

I changed the battery in my 2005 PT Cruiser and now the power windows don't work. I checked all the fuses I could see, the owners manual does not tell what fuse go the the windows. Any suggestions?


You will need to take it to the dealer to get the computer re programed. It happened to my 05 pt convertible and the windows and top would not work. this is not a warrenty item it is software. about $ 400.00 DLRs. Nash Ox CA.

Nov 20, 2010 | 2005 Chrysler PT Cruiser

1 Answer

When tun on the a/c to my 05 pt cruiser it doesnt


This is because the engine does not accelerate and the RPM falls below the minimum the PCM is in charge of sending a signal for the engine to increase the RPM.Thanks

Feb 27, 2010 | 2005 Chrysler PT Cruiser

1 Answer

05 pt cruiser conv. r windows not working after batt died


I have a 2004 Chrysler PT Cruiser Convertiable. Both windows on the driverside will not go down when you open the door. I have replaced the window switch and that is not the problem.

Oct 06, 2009 | Chrysler PT Cruiser Cars & Trucks

2 Answers

I have 2002 pt cruiser Put new upper and lower


IT SOUNDS LIKE THE MAIN MOUNT IN FRAME ON PASS SIDE IS BROKEN..I HAVE NEVER SEEN ONE BROKEN BEFORE OR REPLACED ONE,BUT IT WOULD A FAIR JOB TO REPLACE..ALSO THE BOLT THAT GOES THRU FROM FENDERWELL MAY BE BROKEN..CAUSING YOUR PROBLEM..THERE IS A SMALL PLASTIC PLUG IN FENDER WELL..ABOUT AN INCH OR SO IN DIAMETER..THERE IS A TORX BOLT(T55)IN BEHIND PLUG..CHECK AND SEE IF IT'S NOT BROKEN..TRY TIGHTENING OR LOOSENING IT..IT MAY BE BROKEN OFF IN PLATE THAT IS BOLTED TO ENGINE..LET ME KNOW WHAT YOU FIND

Sep 08, 2009 | 2002 Chrysler PT Cruiser

1 Answer

05 pt cruiser touring turbo code po 302


you have a carbon build up problem try running lucas gas treatment in the car with a full tank of mid grade gas if this does not cure it leave another post and I will give you then next step to fix it, or you can go to http://www.alldatadiy.com and buy a subscription and read all of the recalls and coustmer trouble problems to help locate the problem.

Jun 17, 2009 | 2006 Chrysler PT Cruiser

Not finding what you are looking for?
2005 Chrysler PT Cruiser Logo

Related Topics:

46 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8201 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...