Question about 2005 Chrysler 300

Open Question

Button on 300c nav not working. must have a collar broken underneath that helps you toggle back and forth. Anybody know way to fix without sending in to chrysler for $480?

Posted by on


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Why nav. buttons not working

it is probably broken take to a audio repairer or just get a new radio

Jul 08, 2014 | 2003 Cadillac CTS

1 Answer

My 2009 300C Touring radio/navigation system was randomly shutting down and turning on again and on/off button was useless

just upgrade it. a new one will be less costlys than fixing the old.
make sure fuse to it are not loose. (or hairline cracked inside) new fuses are very cheap.
loose connector to it.
check for 12vdc to the radio when dead.

Jun 28, 2014 | 2007 Chrysler 300C CRD

1 Answer

My abs light on and brake light wont I'm getting gear engaged without brake that when my brake light stayed on can anybody help I put new battery new brakes new sensors front and back it won't reset...

Without a scan-tool it is a lot harder to look at live data and codes. The ABS light is on due to the ABS module identifying a failure within the system. Can you have the codes read and forward them to me, before you continue? I don't know if you replaced the Battery, front and rear Brakes and Sensors, because you thought it would help or because they were in failure. It sounds like you have a code reader. How else would you know if the rear sensor code/s reset? Please write-back with specific details about your BMW. You are the eyes and ears of project. The more you can elaborate on vehicle information and all of the above, the better I can help you. I will say, from your description, it sounds like your brake-light switch has either lost power or is worn out (broken). Without a working brake-light switch, your ABS system can not operate correctly and TCC (torque convertor clutch) inside your transmission won't release, when requested to. Look into this circuit and let me know what you find, good luck.

Mar 16, 2014 | Cars & Trucks

1 Answer

2005 Jeep will not shift into gear stuck in reverse but rolls like in neutral

sounds like the shift cable is broken or out of adjustment

Sep 03, 2012 | Cars & Trucks

1 Answer

Broken wires ac wont cool

I have discussed this with you and have advised you that you need to see dealer assistance on this.

Jun 25, 2012 | Volkswagen Golf Cars & Trucks

1 Answer

My 2005 Mini Cooper S has two issues, NAV display and wipers..

I have a 2005 Mini cooper that the navigation screen is blank. All functions work but no display. Can anybody help?

Thanks, Lenny

Mar 17, 2012 | 2005 Mini Cooper S

1 Answer

Interior lights flash and power locks open and close. The light fuse was pulled and stopped the lights from flashing but the locks still fluctuate when driving. There is a relay near the fuse block that is...

I don't about the door locks but my 01 Grand Cherokee had the interior light problem also. I would just be driving around normally and they would come on or flash without touching anything. Mine was the turn signal toggle, something was loose in it and when my lights came on i could just tap the toggle either up or down and the lights would go back off. Try putting the fuse back in and try the lite tapping thing when it the lights flicker on. It really simple to replace if thats the problem and could some how be connected to you locks since they are both electrical. If you need to replace the toggle just take off the collar around your steering column and then you should see where the toggle connects to the column. there should be a wire connector and a few screws. i found a replacement toggle at a junk yard for only about $50. Hope this helps and good luck.

Mar 31, 2010 | 1999 Jeep Grand Cherokee

1 Answer

How do I replace the sat nav disc

slide the passanger side seat forward and look underneath. there should be a access panel in the floor
and a button on the inner side to eject the nav disc.

Feb 22, 2009 | 2002 Mini Cooper

1 Answer

Toggle switch attached to battery or starter

first of all i need to know if the vehicle will start without the toggle switch? if it does then you can just remove it if the vehicle will not start without turning the switch on you should know that the initial power is from this switch so mostly you have problem in the ignition switch and you have to repair or replace the ignition switch before yo disengage the toggle switch.

Jan 14, 2009 | 1987 Chevrolet S-10 Pickup

Not finding what you are looking for?
2005 Chrysler 300 Logo

Related Topics:

38 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

77201 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers


Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides