Question about 1989 Buick Park Avenue

Open Question

How do you replace battery cables on 1989 buick park avenue

Posted by on

Ad

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 132 Answers

SOURCE: fusebox diagram for 1989 buick park avenue

hi try Buick car owners club or an auto electrician that specializes in Buick is guaranteed to have a copy hope this helps glenn.......

Posted on Nov 10, 2008

Ad
ftw1952
  • 10319 Answers

SOURCE: 1989 buick park avenue Cannot get power window

These are a pain to do so you will need to remove the small trim peice behind the inside door handle to get to a small screw holding the door trim on. Next retaining clips hold on the sides and bottom door trim. Some screws may be on the bottom too on some models. using an old tablr fork helps out by removing the center fork prongs which will be used as a pry bar to pry up on these clips. Once removed you can gain access to the switch. Some models will let you pry out the switch panel instead of removing the whole door trim. If the switch is mounted in a panel that is separate from the door trim it will come out that way separately

Posted on Apr 17, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need to replace the fuse for the turn signals, where would I find them?


1989 Buick Park Avenue ? Didn't have ParK Ave. that year . Buick Park Avenue
It became an Electra trim level in 1978 and its own model starting in 1991 after the Electra was discontinued. Two generations of the Park Avenue were manufactured in the United States until 2005, while in 2007 the nameplate was revived on a large Buick sedan built by Shanghai GM for the Chinese market based on the Holden Caprice from the WM/WN range. The nameplate is derived from the affluent

Feb 07, 2017 | Buick Park Avenue Cars & Trucks

1 Answer

Need to replace radiator in 1989 buick park ave


Hi Dave,here's a guide on how to replace your thermostat.

Feb 06, 2013 | 1989 Buick Park Avenue

1 Answer

1989 buick park avenue


Obviously you have some type of short in the power seat electrical system. Try checking the ground side of each switch with a multimeter. you should not have any current on the ground side of your switch unless the switch is activated. And look for chaffing or short circuits in the wires

Aug 05, 2012 | 1989 Buick Park Avenue

1 Answer

How do i find out if voltage regulator is charging on my 1989 buick park avenue electra


In my case the switch(off/on)was not turning off all the way sooo,i just replace the sw.I did the same thing as you w/battery.Sometimes just think about the last thing you messed with-go backwards on &back.

Feb 18, 2012 | 1989 Buick Park Avenue

1 Answer

My 1993 Buick Park Avenue just Clicks once when you turn the key on starter won't engage the battery is fine


Sounds like a bad starter or a bad battery cable connection to me. If you are certain that tyour battery is in good condition and fully charged, your battery cables are clean and tight and are making good connection on BOTH ends, replace the starter.

Nov 25, 2011 | 1993 Buick Park Avenue

1 Answer

How do you change a light bulb above the license plate in a 1989 buick park avenue


How do you change a light bulb above the license Problem with the 1989 Buick Park Avenue

Oct 08, 2010 | 1989 Buick Park Avenue

1 Answer

How *** I change the headlight on a 1988 Buick


you do not need to remove the lens assembly , only the bulb is replaced, you may need to loosen the battery if its in the way. if i remember correctly there is a black ring just a quarter turn then bulb pulls out. if no ring its just a quarter turn with the bulb and it out

Nov 08, 2009 | 1989 Buick Park Avenue

1 Answer

Fusebox diagram for 1989 buick park avenue


hi try Buick car owners club or an auto electrician that specializes in Buick is guaranteed to have a copy hope this helps glenn.......

Nov 10, 2008 | 1989 Buick Park Avenue

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...