Question about 2002 Chevrolet Monte Carlo

Open Question

Need to replace rear bumper on 2002 monte carlo

I was in a accident last night and need to replace my back bumper because it was crushed in. what parts do i need to completely replace my rear bumper on a 2002 chevy monte carlo? and how much will it cost for parts and labor? help please!!!!

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
wickedsteele
  • 56 Answers

SOURCE: windshield wipers

You will need to replace the wiper motor. Most likely the circuit board is bad. You might check with your local chevy dealer and see if there is a recall on the wiper motor before you buy a new one, even if you are not the original owner the car the recall will still be done free of charge. Some chevy models did have a wiper recall. I hope this helps.

Posted on Aug 09, 2008

Ad
emissionwiz
  • 80407 Answers

SOURCE: 2004 monte carlo sunroof won't close

THERE IS NO MAN OVERIDE, REMOVE THE DRIVE MOTROR AND THE SUNROOF WILL CLOSE.

Posted on Dec 11, 2008

ginko
  • 19396 Answers

SOURCE: 2002 monte carlo ss

The fuel filter is located in the pressure line that runs from the fuel tank to the engine, near to the fuel tank.
Keep the engine off for few hours before replacing the filter, to get rid of some pressure in the lines.

Posted on Feb 27, 2009

  • 106 Answers

SOURCE: Parts trouble.

  • it should just see if bolt pattern matches up with the other it should match up!!!

Posted on Mar 26, 2009

litoshop
  • 298 Answers

SOURCE: 2002 chevy monte carlo won't start

this vehicle is equipped with a factory anti theft system if when you try to start the engine and the anti theft light is on then the starter won't start even if your check engine light is not on you would have to scan the body module to pin point the problem to see if it's the anti theft system or the starter, go to a auto parts store like auto zone or pep boys or western auto these store offer free scanning to there customers. if this information has been helpful please let use know good luck

Posted on Jul 28, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to correct a 2005 chevy monte carlo high beams from staying on


About 17,700 results (0.74 seconds) Search Results

    My high beams won't go off!! - Monte Carlo Forum - Monte Carlo ...

    montecarloforum.com > ... > General Forums > General Monte Carlo Talk
    Jun 8, 2012 - i flipped on the high beams last night and i think that switch in the column broke. ... My high beams won't go off! ... 2003 Chevrolet Monte Carlo. Help!! Need to get headlights working. - Monte Carlo Forum ...
    Jan 1, 2012
    Repair Guide: List of Common Monte Carlo Problems and Solutions ...
    Aug 9, 2011
    Fog lights not working, High beams stay on?
    May 9, 2011
    More results from montecarloforum.com

Jan 30, 2016 | 2005 Chevrolet Chevrolet Impala LS

1 Answer

Where is the airbag impact sensor on the fender


Not too sure but the last time i checked it was on behind the bumper on the reinforcement bar or bumper support that goes from one side of the frame to the other and i belief their was a recall on that.You could also ask your dealer for a diagram.

May 27, 2014 | 1995 Chevrolet Monte Carlo

1 Answer

95 chevy blazer. Was in car accident. Is the rear bumper assembly able to be replaced or is it a single piece frame. Just in case it is twisted.


the blazer bumper is made up of about 6-10 parts including the brackets. it can be purchase by each part or as an assembly. the frame should be measured to insure it was not twisted. try www.car-parts.com for salvage parts in your area. good luck

May 13, 2011 | Chevrolet Blazer Cars & Trucks

2 Answers

I csrashed into afire hydrant..had the front bumper replaced..but my steering wheel wont lock,when key is removed


sounds like the steering colum has collapses slightly. Have a profesional chek it. Did the airbags deploy?

Mar 17, 2011 | 1999 Dodge Durango

1 Answer

Replace front hub bearings on 2002 chevy monte carlo


road wheel off, brake caliper removed from rotor disc, remove cap in middle of rotor exposing the bearing retaining nut, remove split pin that holds the nut from turning and wind off the large nut, once nut is removed you can remove the rotor and bearings, the rear roller bearing at the rear of the rotor may need to be levered off with a screwdriver, should come off easy, replace in reverse order

Jun 11, 2010 | 2002 Chevrolet Monte Carlo

1 Answer

What parts are needed for replacing the front end of a 2001 monte carlo? I find bumper covers, reinforcements, energy absorbers, etc. Do I need some or all of these?


It depends on how far in the damage goes. Usually fenders, hood, bumper cover and headlights, but if the damage is deep, you could need a bumper, absorbers, the bumper mounts, even the radiator support assembly, which requires welding.

Pull off the damaged parts and set them aside, and then go to gmpartsdirect.com and click on the catalog link, fill in your make and model and look for the bodyparts you need to replace.

Apr 04, 2010 | 2001 Chevrolet Monte Carlo

1 Answer

1995 Mercury Villager that was in an accident - bumper sticks out


I would go to a pick N pull salavge yard and buy an entire used bumper assembly.

http://groups.yahoo.com/group/villagerquest/

Mar 29, 2010 | 1995 Mercury Villager

1 Answer

Reverse backing sensor doesn't beep when backing


They have most likely painted over the sensors in the rear bumper or the module has fialed or the sensors are not plugged, one other slim posibility is the siren in the module is faulty.

Mar 16, 2010 | 2005 Ford Five Hundred

Not finding what you are looking for?
2002 Chevrolet Monte Carlo Logo

Related Topics:

87 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

80407 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...