Question about 2000 BMW 3 Series

2 Answers

Bmw drivers side wheel rattle over bumps on the road

Posted by on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 2,030 Answers

You may have a wheel bearing, Strut, bushing, ball joint, or tie rod worn out.

Only way to really tell is take it to a mechanic and have it checked..most will do this for free. Especially if you take it to one of the national chain repair shops that give free estimates.

Posted on Sep 11, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,129 Answers

The car must be jack up, then on that side look under the inside of the front where the wheel attaches, look at the suspension parts there is probably going to be a broken stabilizer link rod, my BMW 528i did the same thing it turn out to be the stabilizer link rod.

Posted on Sep 11, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Its a rattle sound on passenger side mostly when go over a bump


The most common thing on commodores when going over bumps or over pot hole in the road is rattle or knock from front.
you will more than likely need new sway bar link pins and bushes..

Jan 09, 2014 | 1998 Holden VT Commodore

1 Answer

RATTLING NOISE ON THE PASSENGER SIDE FRONT TIRE


The first thing to check on a rattling noise is if going over minor bumps in the road if that is when it makes noise is a sway bar link, they make a rattling noise. If you raise that wheel up you might also want to try and wobble the wheel to be sure it is not a tie rod end or ball joint. Typically I run into the sway bar links or the sway bar bushings making the noise. However ive even seen it be a rock sitting on the strut plate.

Jul 24, 2010 | 2008 Chrysler 300

1 Answer

What should i look for when buying a 97 bmw 528i. Im about to purchase one off of my machanic ive been going to over 6yrs. He siad its in excelent condition and theres nothing wrong with it. it look mint...


Take the car for a test drive, around town, and on the freeway. Notice how well and when it shifts, listen for any unusual noises and rattles when hitting bumps. Have the car put on a lift and check the underneath side for any wets spots of pssoble leaks. If possible, remove the wheels and check the brakes and struts.

Apr 24, 2010 | 2000 BMW 5 Series

2 Answers

Driver's side rear wheel leaking brake fluid and has a rattling noise. what could this be?


wheel cylinder needs replacing; rattle may be coming from broken wheel cylinder; consult your local mechanic, or if you are mechanically inclined., DIY. :-)

Oct 06, 2009 | 2003 Lincoln Town Car

1 Answer

Clunk noise from front passenger side when


That noise sounds to me like a Ball Joint problem. I would check to see if you have fittings to grease the front suspention.

Good luck, Allen

Oct 04, 2009 | 2005 Nissan Sentra

1 Answer

Rattle under car going over bumps


Take a close look at your springs. My 99 Audi A4 had a creaking rattle that happened when I went over a speed bump or dip in the road, and it turned out the bottom of each rear spring was broken. I replaced them and the noise went away.

Another possibility would be the sway bar end links. Since the sway bar is worked pretty hard, the bushings in the end links will wear out eventually. This can cause some clanking. Look behind the wheel hubs - you should see a short bar or bracket attached to the hub at one end, and to a bar at the other end. The bar will go forward or back a short way, and then across the bottom of the car to the other wheel hub. That's your sway bar. The bushings in the end links (the short attachment bars that anchor it to the wheel hub) or in the body brackets (some cars bold the center of the sway bar to the body with a bushing in a bracket) could be deteriorated and allowing the bar to bang around on the body.

Finally, take a look at the suspension itself. Do any of the bushings where various parts meet appear to be cracked, leaking fluid, or gone entirely? There should be no gaps between any suspension pieces at the points where they meet. If there are, you're missing some bushings and may well have found the source of your noise.

Jul 21, 2008 | 1999 BMW 318 ti

3 Answers

Banging noise from rear of bmw 316 e36


It could be your subframe as well big problem with E36's. Also you can check your Rear Shock Mounts in the trunk by removing the carpet, they are under the speakers. Also check your brake pads, the little shim could have fallen off causing your brake pad to rattle over bumps. And check all your heat shields.

Jun 09, 2008 | 1997 BMW 318

Not finding what you are looking for?
2000 BMW 3 Series Logo

258 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Frankie B

Level 2 Expert

65 Answers

Fred Sops

Level 2 Expert

272 Answers

Doberman

Level 2 Expert

254 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...