Question about 2000 Jaguar S-Type

1 Answer

What does failed front rh indictor means - 2000 Jaguar S-Type

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 242 Answers

Your front passanger side turn signal bulb is burnt out.

Posted on Sep 11, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Need to know where 2001 jaguar xk6 terminal under hood,battery is in back but when battery is dead can not open trunk,this happened one other time and can not remember where it is ,somewhere on left if you...

do you mean xk8? if so there is a B+ post under the bonnet rh has you sit in car. if it is rh drive it is on the plastic housing that contains the brake master cylinder, there is also a key slot in the rh boot badge for key access but that normally siezes up because it is rarely used. try putting some wd40 in it and keep trying to get it to work. note it will not work with the green valet key, only the black key. good luck.

Mar 16, 2015 | 2001 Jaguar XK-Series

1 Answer

Squealing noise from front pasenger wheel

Your description sounds like the front brakes need to be replaced. There's a wear indictor built into the brake pads that will make this noise when they need to be replaced.

Aug 19, 2011 | 2005 Pontiac Sunfire

1 Answer

What does failed front RH indicator mean

Exactly what it says. the lamp in your front turn indicator is not working - check replace bulb.

Dec 16, 2010 | 2000 Jaguar S-Type

1 Answer

Jaguar 2002 failed rear rh indicator failed means what

That your right hand indicator bulb is not working, probably loose connection or burned out.

Aug 20, 2010 | Jaguar S-Type Cars & Trucks

1 Answer

How you take off the front bumber

have 96, 95 similar

Section 01-19: Bumpers 1996 Villager Workshop Manual
REMOVAL AND INSTALLATION Bumper and Bumper Cover Front
  1. Raise and support the vehicle.
  1. Remove the RH and LH front wheel (1007).
  1. Remove the RH and LH front fender splash shield screws. Remove the RH and LH front fender splash shields (16102).

  1. Remove the four front fender brace screws.

  1. Remove the two front fender brace nuts.
  1. Remove the two plastic screws.
  1. Remove the seven clip buttons located under the front bumper cover (17D957).

  1. Remove the RH and LH front turn signal lamps (13369). Refer to Section 17-01 for the removal procedure.
  1. Remove the four front bumper cover brace bolts.

  1. Remove the front bumper cover from the vehicle.

  1. Remove the two front turn signal lamp wire harnesses from the front bumper (17757).

  2. Remove the eight front bumper bolts.

  1. Remove the front bumper from the vehicle.

Mar 02, 2010 | 1995 Mercury Villager

1 Answer

Which is the piston number 1 in suzuki lx7 2004

It is the front, LH side one. They are numbered 1,3, and 5, front to rear on the LH bank, and 2, 4, and 6, front to rear on the RH bank. RH bank is the RH side of the car (looking from the rear).

Dec 30, 2009 | 2004 Suzuki XL-7

2 Answers

"Failed RH Indicator"

Check your right hand indicator bulbs, front and rear.
Simply a case of changing a blown light bulb.

Sep 17, 2009 | 2001 Jaguar S-Type

3 Answers


Simple, it just means that one of the right hand flasher bulbs, either back center or front, is burnt out. If all the bulbs are ok, there is probably still one not flashig because of faulty wiring or something in the same line like a switch malfunction or in newer technology, onboard computer malfunction. Being a jaguar, if the bulbs are all OK and you still got a problem, i'd suggest having it checked by the dealer.

Jul 07, 2009 | 2000 Jaguar S-Type

1 Answer

Error message & blinker

it means that theres a broken bulb. all you need to do is replace it,

Aug 01, 2008 | 2000 Jaguar S-Type

Not finding what you are looking for?
2000 Jaguar S-Type Logo

Related Topics:

62 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers


Level 3 Expert

76630 Answers


Level 2 Expert

489 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides