Question about 1999 Dodge Caravan

1 Answer

99 dodge caravan speed sensor location - 1999 Dodge Caravan

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 149 Answers

Theres 2 they are on top of the trans. The input is closest to the engine,below the trans lines going into the trans. The output is to the right of the lines about foot still on top. 1 inch deep well socket need to remove. 20 lbs torque. Make sure to use new o-ring


























































































































Posted on Jan 20, 2010

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 154 Answers

SOURCE: location of speed sensor a for 99 dodge intrepid

The "Vehicle Speed Sensor" signal is generated by the transmisson output speed sensor. That is the one located at the rear of the case. It is externally mounted. That supplies "vehicle speed" info to the other On-Board Computers. The input turbine speed sensor is located just behind the bell housing area of the case. I believe the trans controller is the only module that needs that info. The Crank Position Sensor give engine RPM info and it is located on the bell housing near the engine block. I hope this helps.

Posted on Apr 02, 2009

  • 1 Answer

SOURCE: transmission input speed sensor location

It is located on the front of the transmission. you will see 2 of them one on the left under small transmission lines it is the input then to the right behind the radiator overflow there is the other one. Easiest way to change them is with a 1" deep well socket

Posted on Jun 02, 2009

  • 412 Answers

SOURCE: i have a 1996 dodge caravan with the 3 speed

A 3 SPD TRANS DOES NOT HAVE INPUT/OUTPUT SENSORS..ONLY A VEHICLE SPEED SENSOR..IT IS LOCATED ON TRANS EXTENSION HOUSING WHERE RIGHT SIDE AXLE COMES OUT OF TRANS..1 BOLT AND A WIRE CONNECTOR

Posted on Jul 19, 2009

  • 162 Answers

SOURCE: WHERE ARE THE VEHICLE SPEED SENSORS LOCATED ON A

Both front wheel hub assembly would have those sensor they are also used for the abs. I am not sure on that year of caravans would have some on the rear wheel hub assembly also.

Posted on Oct 09, 2009

CANSDALED
  • 14 Answers

SOURCE: where is the speed sensor located on my 1999 dodge

THEIR IS 2 A INPUT AND A OUT PUT THEY ARE ON THE FRONT OF THE TRANS JUST ABOVE THE 16 PIN CONECTOR OR NEXT TO THE TRANS COOLER LINES

Posted on Aug 17, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why did my 99 dodge grand caravans speedometer stop working?


Best guess :Check the speed sensor on the transmission, these fail.

Jul 21, 2014 | 1999 Dodge Caravan

1 Answer

Location of speed sensor on transmission 1997 gr caravan 3.3 engine


The input speed sensor is right below where the cooler lines are clamped the the transmission. The output speed sensor looks exactly the same as the input and is located to the right ( as you standing in front of the vehicle) of the input speed sensor.

Sep 25, 2011 | 1997 Dodge Grand Caravan

1 Answer

99 dodge caravan code po 734 what does it mean


P0734 is a transmission code. The code description is: Additional gear ratio in fourth gear. The most likely cause is the input speed sensor on the transmission, a common problem. The sensor is located on the side of the transmission facing the grill right above the solenoid pack. You need to check the resistance of the sensor. It should be between 500 to 700 ohms. If it tests open, the sensor is bad. If not check the connection and the wiring.

Apr 08, 2011 | 1999 Dodge Caravan

1 Answer

How to change speed seonsor on my dodge caravan 2001


first disconnect the negative wire frim the battery. then look on the front side of transmission about middle ways to locate vehicle speed sensor. disconnect the electrical plug from sensor. remove the retaining bolt and lift the vehicle speed sensor from the transmission. replace in the reverse of removal.

May 03, 2010 | 2000 Dodge Caravan

1 Answer

Dodge caravan 96, doesn't ship to 3er gear, just


i would start with the speed sensor on tip of the tranny if i was you. generally when the speed sensor goes it de- rates engine, because computer doesn't know what is happening.its located on passenger side where axle goes into transmission.

Jan 26, 2010 | 2001 Dodge Grand Caravan

1 Answer

I have a 1996 dodge caravan with the 3 speed transmission and i need to find out the exact location of the input and output speed sensors thanksi


A 3 SPD TRANS DOES NOT HAVE INPUT/OUTPUT SENSORS..ONLY A VEHICLE SPEED SENSOR..IT IS LOCATED ON TRANS EXTENSION HOUSING WHERE RIGHT SIDE AXLE COMES OUT OF TRANS..1 BOLT AND A WIRE CONNECTOR

Jul 18, 2009 | 1996 Dodge Caravan

1 Answer

How long would it take to replace the output speed sensor? I have a 99 caravan SE


!/2 hr-1hr. labor, on hoist. 1/2 should do it. part will be $15-$45 depending on your particular transmission. Unless you were talking about ABS speed sensor.

Jul 13, 2009 | 2001 Dodge Caravan

1 Answer

Location of speed sensor a for 99 dodge intrepid


The "Vehicle Speed Sensor" signal is generated by the transmisson output speed sensor. That is the one located at the rear of the case. It is externally mounted. That supplies "vehicle speed" info to the other On-Board Computers. The input turbine speed sensor is located just behind the bell housing area of the case. I believe the trans controller is the only module that needs that info. The Crank Position Sensor give engine RPM info and it is located on the bell housing near the engine block. I hope this helps.

Mar 29, 2009 | 1999 Dodge Intrepid

3 Answers

Transmission input speed sensor location


It is located on the front of the transmission. you will see 2 of them one on the left under small transmission lines it is the input then to the right behind the radiator overflow there is the other one. Easiest way to change them is with a 1" deep well socket

Jan 19, 2009 | 2001 Dodge Caravan

1 Answer

Transmition sensor location


input and output speed sensors are located on the side of the transmission case across from each other. they are plastic and screw into the trans on 3.3l and 3.8l 3.0 may have the sensor where the pass side axle goes into the tranny

Jul 27, 2008 | 1997 Dodge Caravan

Not finding what you are looking for?
1999 Dodge Caravan Logo

1,439 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8499 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...