Question about 2008 Ford Fusion

3 Answers

I have a 2008 ford fusion and the battery keeps dieing because theres a draw somewhere but i have no idea where to begin looking. this is the 3rd battery in 3 months

Posted by on

Ad

3 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 52 Answers

Wow 3 batteries in 3 months???? undo the positive battery cable & connect a test light in between the + cable & the + battery. the light will go on if there is a draw, start pulling the fuses out one at a time until the light goes out then you know what circuit the problem is on. make sure you take the interior light out as the door being open will cause the test light to go on. This is called a parasidic loss..

Posted on Sep 11, 2009

Ad
  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 4 Answers

Make sure both your connections are clean and tight, particularly the neg,(-).

Posted on Nov 28, 2012

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 631 Answers

You can unhook your positive lead to your battery and hook a test light on your positive lead then to the negative side of your battery and see if it lights up. If it lights up then you have a draw. Start pulling one fuse at a time until it kills the test light. When it kills the test light you have narrowed it down to what is drawing the power. Test lights are about 10 to 15 dollars for a cheap one. It will work though.

Posted on Sep 11, 2009

  • outdoorsman5
    outdoorsman5 Sep 11, 2009

    Oh leave your key-switch off when you run the tests. And test-light should be connected inline.

  • turple Aug 31, 2010

    what about the clock an the alarm they draw all the time

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2007 Ford Fusion dash bulge under passenger side airbag. How can I fix it?


Take it to a garage to look at. They are two dangerous to try and fix your self. There were massive recalls on Takata Airbags and your vehicle seems part of it. There are hundreds of complaints. Take it to a local dealership.

2007 Ford Fusion dash bulge under passenger side airbag Google Search

https://ford.oemdtc.com/1348/warped-or-distorted-instrument-panel-around-passenger-air-bag-2006-2008-ford-fusion-2007-2008-mecury-milan

FORD FUSION Problems 2007 FORD FUSION Air Bags Problems

Nov 24, 2017 | Ford Cars & Trucks

2 Answers

2014 ford fusion engine wont crank after wreck


Ford fusion won't start - YouTube

? 2:01
www.youtube.com/watch?v=H0BhHWT2cyY
Sep 16, 2014 - Uploaded by mlmunoz21
Ford fusion won't start ... Published on Sep 16, 2014 .... 2004-2008 F150 Died Out No Crank Theft Light ...

Ford Fusion won't start - YouTube

? 0:32
www.youtube.com/watch?v=lmH7R6Ebmyc
Jan 9, 2015 - Uploaded by Nicholas A.
Any ideas why it won't start? 2007 ford Fusion awd 6 cylinder. ... And P1260 2007 Ford Fusion - Theft ...

Nov 02, 2015 | 2014 Ford Fusion

1 Answer

Battery keeps dieing even after changing it twice.jump starts no problem.airbag light stays on aswell.


1st thing to check is where the ground battery wire attaches to the frame of the car - sometimes they get loose and don't make a good connection anymore (if so, just tighten it). You could also look for obvious problems with both battery wires (insulation worn off etc).

On my Civic, the airbag light will go on after the battery is taken out (or dies), and it has to be reset manually. It's easy to do, but at a dealer they'll charge $50-$100 for it. I have no idea if a Ford Fusion is the same way though, so you could check some car forums or just shell out at a dealer where you can be sure they'll fix it.

Sep 28, 2012 | 2010 Ford Fusion SEL

2 Answers

My battery went dead on my ford fusion 2008 now my radio doesn't work


As with many newr cars, Your radio probably had a security code which is required to reset it after the radio is removed or power was disconnected from it. You probably have the code written somewhere in your new car paperwork. If not, contact your dealer. They can probably guide you through resetting the code.

Nov 03, 2010 | 2006 Ford Fusion

1 Answer

I have a 2008 Ford Fusion with approximately 55K miles, have had one instance where the car would not start - turned key on "Click","Click", "Click" - checked battery, battery was low on water - filled...


Best way is to go to Autozone or Oreillys and get a free scan. They could also do a Starter draw test to see if it is okay.

The scan will tell you what the Code is for the Check light and Autozone or Oreillys can reset your Check light. If the Battery boiled away the water, then it is either overcharging or you have a high draw of current.

There use to be a test of taking off the Battery cable while the engine was running and if the Alternator was good your car would keep running. But with the new Electronics using this method may hurt the delicate Electronics somewhere else in the car.

Sep 26, 2010 | 2008 Ford Fusion

1 Answer

Tag lights for 08 ford fusion need replacing. One fixture is broken. Where can I find repalcements?


these specilty fixtires are more of a dealer only type item. i doubt youll find one anywhere other than a ford dealer unless you find a used one somewhere.

Nov 30, 2009 | 2008 Ford Fusion

1 Answer

Rear bumper on Ford fusion


Are there holes for them? Then yes, if not then no.

Mar 11, 2009 | 2008 Ford Fusion

1 Answer

Mp3 audio input jack on 2008 ford fusion


use an audio patch cable, 3.5mm. You can get it at radioshack. I don't have my fusion yet (getting hybrid!), so I'm not surem but there should be a line-in, input or mp3 mode on the radio somewhere.

Nov 17, 2008 | 2008 Ford Fusion

Not finding what you are looking for?
Cars & Trucks Logo

1,318 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

78267 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

fordexpert

Level 3 Expert

5655 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...