Question about 2000 Plymouth Voyager

1 Answer

How do you disconnect the quick connect fuel line(pressure line) from the fuel rail,under the hood. 2000 plymouth voyager 3.0 engine.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 52 Answers

There should be a quick connect adapter that you can buy from canadian tire for around $5. it slides on the fuel line & up into the fitting.

Posted on Sep 10, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the fuel pressure regulator on 1996 Plymouth grand voyager


I looked at info for the 3.3L ohv engine.
My info shows it is located at the fuel pump assembly in the gas tank.

Have you looked for external leaks, under the vehicle, under the hood? You may be able to use fuel pressure gage, cycle the key to bring up fuel pressure, turn key off, see if pressure holds for a bit? Also, check evap system.

Feb 27, 2017 | Plymouth Cars & Trucks

1 Answer

Where is the fuel filter on a 1987 voyager


The filter is an in line filter, probably under the car along the frame rail where the fuel line runs from the gas tank to the engine. There is a bracket and a bolt holding it in place. Follow the fuel line from the tank forward-you should see it.
The fuel pump is inside the gas tank. If you suspect a pump problem because no pressure is in the line or at the injectors, an easy way to check is to see if there is power on the fuel pump wire at the gas tank connector, while the engine is being cranked over. If you have power on the wire then, but no pump sound or gas in the fuel line when the connector is connected, then the pump has failed and needs replaced.

May 20, 2014 | 1987 Plymouth Voyager

1 Answer

2000 Plymouth Grand Voyager having issues starting


i would think that you need to look for a leak, there are rubber hoses attached to your steel lines under your van and in the engine compartment, as well as your fuel pump. start your van with the parking brake applied, and tires blocked, then you can trace your fuel lines out, just remember if you dont see a wet spot that doesnt mean theres no leak, your looking for dry rotted hose. what could be causeing a starting delay could be that its sucking air, and if your fuel pump is under the hood, then the fuel line going from the fuel tank to the front is a suction hose, if you have a fuel pump in the fuel tank the that line is a pressure hose. hope this helps

Aug 11, 2012 | 2000 Plymouth Grand Voyager

1 Answer

How to tell if fuel line is plugged


If you open your hood and look along your fuel rail, you should see a "check valve", Looks alot like a car tire valve(may or may not have a black cap on it.
Take the cap off, and push down on the plunger.
Hold it down and have someone cycle the key to the on position.
(WITH CAUTION) fuel WILL spray out(as long as your fuel pump is good/line filter not clogged.
If it shoots out, you have good pressure your fuel pump is good, lines are NOT clogged.
IF it shoots out(WITH GOOD pressure) i would suggest replacing your fuel filter
If it DOES NOT shoot out, Your fuel pump is no good

May 30, 2012 | 2000 Plymouth Voyager

1 Answer

How do you remove a fuel pump on a 97 plymouth grand voyager


    • 1 Make sure the engine is completely cool. Relieve the pressure in the fuel system. Disconnect the negative battery cable. Elevate the vehicle and support the fuel tank with a jack.
    • 2 Disconnect the fuel line from the front of the tank. Remove the ground strap, the inboard side fuel tank straps and the front T-strap fastener, then lower the tank approximately six inches.
    • 3 Take the fuel lines from the fuel pump module. Plug the fuel lines with golf tees to prevent the spillage of gasoline. Remove the fuel filter.
    • 4 Install the new fuel filter. Set the bolts in place and torque them to 40 inch/pounds. Tighten the main tank straps to 40 foot/pounds and the T-strap to 250 inch lbs.
    • 5 Reconnect the fuel lines in the reverse order of their removal. Lower the vehicle. Connect the negative battery cable.
    • 6 Start the engine and let it run for several minutes. Inspect the fuel lines for any leaks.


Read more: How to Replace a Fuel Filter in a Plymouth Voyager ' eHow.com http://www.ehow.com/how_4519932_replace-fuel-filter-plymouth-voyager.html#ixzz1WBXAZ7d3

Aug 27, 2011 | 1997 Plymouth Voyager

1 Answer

Where does the fuel line hook up to the engine


the fuel lines [2] connect to the fuel rails behind the distributor. There are quick connect fittings and are under pressure and should be relieved before disconnecting. also battery should be disconnected.

Sep 28, 2010 | 1995 Plymouth Voyager

1 Answer

How do i change the fuel filter on 1995 plymouth voyager?


The line is under pressure so be careful when removing the fliter. You should be able to find the fuel pressure test port on the fuel rail under the hood. If you press in the schrader valve it will relieve the fuel pressure in the line and make it less likely to end up in your face when you finally remove the filter.

The filter is located under the vehicle on the passenger side about in the middle.

There will be two short sections of hose on each side of the old filter. Replace those sections of hose. Higher end filters usually come with the hose pieces. Use new fuel hose clamps. They are different than the regular hose clamps and do a much better job of keeping the hoses secure.

Sep 24, 2010 | Plymouth Voyager Cars & Trucks

2 Answers

Where do you relieve the fuel pressure at when changing the fuel filter on a 1996 Plymouth Voyager with a 3.3L engine (short wheel base)


there is no pressure regulator only one is built into the fuel tank to relive the pressure look on fuel rail for a small valve looks like a valve stem similar to tires stem it as a black plastic cover unscrew that and push with a pointy object

Aug 28, 2010 | 1996 Plymouth Voyager

2 Answers

Where is the #6 electronic fuel injection plug for 1999 plymouth grand voyager 3.3 engine


3.3L & 3.8L Engines
Firing order: 1-2-3-4-5-6
Distributorless Ignition System chry-02-33-786.gif
The Driver's Side Front spark plug is the #6 cylinder.

Aug 08, 2010 | 1999 Plymouth Grand Voyager

3 Answers

2000 Chevy Venture Fuel Pressure Regulator


use the pressure test port on the top of the engine, it is on the fuel rail that supplies fuel to the injectors, looks like a tire valve, will have a plastic cap on it.

Mar 22, 2009 | 2000 Chevrolet Venture

Not finding what you are looking for?
2000 Plymouth Voyager Logo

Related Topics:

142 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...