Question about 2002 Jaguar S-Type

4 Answers

Keeps running after turning key off - 2002 Jaguar S-Type

Posted by on

  • gearheadtool Sep 11, 2009

    After you turn the ignition key off, the car keeps running smoothly, a fuse must be pulled under the hood to shut the car off. There are no DTC's.

  • yadayada
    yadayada May 11, 2010

    do u mean dieseling? this is a knocking with very erratic engine idle

×

4 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 1,861 Answers

@ Gearheadtool -

I would disagree with the 3 'solutions' provided to you.

What I believe that you have happening here, is an internal failure in the electrical portion of the ignition switch.

An easy way to check this is to remove the lower part of the instrument panel, under the ignition, and remove the connection from the back of the ignition switch. If the engine shuts off, you have isolated the problem.

Posted on Sep 18, 2009

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I had this happen to me one day I was under the trunk replacing the passenger rear turn signal bulb. I saw a connector unplugged and thought that I had just bumped it loose. I connected it and the car would not shut off. I could turn it off and remove the key. I back tracked and found that this connector would not allow the car to turn off. I still do not know the purpose of it. If anyone knows please post!

Posted on Sep 14, 2009

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

Replace the key... its something with the computer in the key

Posted on Sep 18, 2009

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 10 Answers

Timing is advanced to far

Posted on Sep 11, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I have a TBI on my Chevy and when I turn the key on it keeps running the fuel pump after the 2 seconds like to know what to look for and where to find it


didnt specify year model or engine --generic answer --if the tbi is flooding ---check the fuel pressure regulator --and the tbi itself

Apr 16, 2017 | Cars & Trucks

1 Answer

Why does it start and run, then dies?


Keep ur ear out . If it first turn the key on you'll ear the pum on tank going. If it keeps on then is plug . Another way to chek it is on the fuel injectors line. It looks like tire valve . Slowly press on fuel should came out. If not is the fuel pump. Be careful if u check x pressure keep ur face out of the way.

Jun 24, 2015 | 2006 Dodge Ram Pickup 3500

1 Answer

The starter motor keeps running after you turn the key off


try to check your ignition cylinder specially the back plate of the cylinder for loose or short.

Mar 10, 2015 | Cars & Trucks

1 Answer

My 1990 4runner i turn it over and starts fine and then runns out of gas if i turn it over and keep it turning over after it starts it will keep running


I would check the coil to see if the power side is getting battery voltage with the key in the on position. It could be the key switch.

Jan 12, 2013 | 1990 Toyota 4Runner

1 Answer

Trouble starting keeps running after turning it off


If it is chugging and running rough after you turn the key off, it may be "dieseling" which is caused by carbon buildup in the cylinders and the idle speed being higher than spec. Pulling the coil wire from the coil and the engine continues to run is a good example.

Aug 26, 2012 | 1991 Ford Ranger Supercab

2 Answers

1991 poniac firebird will not start and the secerrity light keeps flashing


The most likely cause of the problem is that your security module is not reading your key correctly. This is usually due to a defective key tumbler assembly. Try this to get it started:

1. Connect a battery charger or connect to another vehicle with jumper cables to keep the battery from running completely dead. If you set your parking brake before turning the key on, this will also help because it will keep your daytime running lamps from coming on.

2. Turn the key to the RUN position and wait about 10 minutes until the security light stops flashing.

3. Without turning the key off, turn the key to the START position and see if the engine will start.

If this does not work to get it started, you will have to tow it.
In either case, (whether you get it started or not, the key tumbler assembly probably needs to get replaced.

May 13, 2011 | 1991 Pontiac Firebird

1 Answer

1999chevy blazer will turn over but won't keep running


are you using the same key you always do ? the key is the problem usually .. these are a pain in the **** .the key is a chip key matched up to your ignition .. . you might have to take it to a dealer to get this repaired right .. not just something you can quick fix usually .. thanks Jerry and holler if you need more.

Apr 27, 2009 | 1999 Chevrolet Blazer

1 Answer

Car keep running when key is turned off


you have a short in the column where the key goes
or the inside is not going back when you turn the key...try maybe a touch of wd40 oil and turn key a few times to see if it helps release

Apr 22, 2009 | Pontiac Sunfire Cars & Trucks

Not finding what you are looking for?
2002 Jaguar S-Type Logo

Related Topics:

857 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

75822 Answers

SPEEDY CAR WORK SHOP...

Level 2 Expert

489 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...