Question about 1991 Pontiac Firebird

1 Answer

Hood pins on a 1991 Pontiac Firebird

How do you install hood pins on a 1991 Pontiac Firebird Formula?

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 21 Answers

Find the point on the radiator support where the pins will be located.Be sure there isn't anything underneath to drill through.Measure from the fender to the center point of the hole location,and measure from the front fascia(edge where the front edge of the hood meets the body)to the center point of the hole location.Use these measurements to mark the hole on the hood.Repeat for the other side.MEASURE TWICE DRILL ONCE.

Posted on Sep 11, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Spark plug gap size for 1991 formula firebird


See if you still have the Vehicle Emission Control Information label (the VECI label) under the hood on some radiator support member, probably. The spark plug gap is listed on it.

Feb 08, 2013 | 1991 Pontiac Firebird

1 Answer

The fuel pump on my 1995 Firebird Formula quit running. I've even tried feeding 12v directly to the grey wire on the fuel pump relay and it still doesn't run. Can a generic fuel pump be installed...


No, the fuel pump in the tank needs to be replaced. It's not too bad to remove the tank, hopefully you don't have much gas in there though.

Good Luck!

May 27, 2011 | 1996 Pontiac Firebird

1 Answer

My 1991 pontiac firebird starts up then dies like in 10 sec. what do i need to do?


pop the hood check your fuel rail make sure getting fuel and check spark plugs make sure they are firing and it sounds like maybe the fuel filter is clogged not letting fuel pass through around 25 dollar fix do it yourself

Sep 24, 2010 | 1991 Pontiac Firebird

1 Answer

All that was done (entry to left), well under


correct on both your guesses. check your firing order making sure that #1 is in the correct place on the cap

May 09, 2010 | 1991 Pontiac Firebird

1 Answer

All that was done (entry to left), well under power, the Formula is no good. Timing was set per lable under hood and looked good, on the road no power, had to set timing approx 20 degrees prior to TDC to...


the sound of what you explained is more that the timing is 180 degrees out... that would explain the no power on the road.... it would also allow the timing marks to line up.... hope this helps

Mar 23, 2010 | 1991 Pontiac Firebird

2 Answers

1991 Firebird Formula, timing shift during warm-up.


Change the coolant sensor, they are faily cheap and usually easy to get to. They are also prone to failure on the early years of fuel injection.

Feb 19, 2010 | 1991 Pontiac Firebird

1 Answer

Is there a breaker or fuse for the fuel pump on a 1991 Pontiac Firebird with a 3.1 leter engine? If either where is it located?


The electric fuel pump's operation on that vehicle is triggered by the powertrain control module, activated by a relay (likley located under the hood in the power distribution center, if not check the fire wall and underhood near the fenders) and protected by a fuse (the fuse is likely located in the fuse block that is under the dash, if not it will be under the hood in the power distribution center).

Oct 24, 2009 | 1991 Pontiac Firebird

1 Answer

Need a vacuum diagram for a 1976 Firebird Formula 350 V8 2 Barrel. A photo of the engine compartment would be nice as well.


Most Haynes manuals now have this info in the back of the book. I am also assuming that the O.E. sticker that shows this info under the hood is missing?

Sep 09, 2009 | Pontiac Firebird Cars & Trucks

1 Answer

Need new ecm for 1991 formula firebird


YOU MIGHT TRY A WRECKING YARD. YOU NEED THE EXACT MATCH TO YOUR ENGINE IN ORDER FOR IT TO BE CORRECT. THE CAR MAY BE WRECKED , BUT THE ELECTRONIC CONTROL MODULE SHOULD BE FINE.

Jan 24, 2009 | 1991 Pontiac Firebird

Not finding what you are looking for?
1991 Pontiac Firebird Logo

Related Topics:

144 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8732 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...