Question about 2004 Jeep Grand Cherokee

1 Answer

How do I change the buld on my fog light? - 2004 Jeep Grand Cherokee

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Jeep Master
  • 17,970 Answers

Jeep WJ 1999-2003 - Front Foglamp (#9055)

How do I change the buld on my fog light? - 1379890.jpg

The foglamp bulbs can be accessed and removed from underneath the bumper without tools, although it is a tight fit. Turn the lamp socket 1/4 turn counter-clockwise to remove from the rear of the housing. Note that the screw in the front of the foglamps is for alignment only and does not remove the outer lens. The fog lamp housing is attached to the fascia with two nuts which can be removed with a 10mm socket.

Fog lamps can be added to most Laredo model WJ's that came from the factory without them. Mopar kits are available that include two fog lights, wiring harness, and steering column switch. Click HERE for part numbers and other information on these kits.


Jeep WJ 2004 - Front Foglamp (#9145)


fc74409.jpg


Good luck (rated this help).

Posted on Sep 10, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Passenger side rear fog on scenic 2 does not have any power


there shouldent be a junction box it will split from the lomb from the same wire going to the rear of the car if the bulb works and there is no power to wire there will be a break in the wire some where usually it would break where it gets twisted possibley where the wires go into the cluster check to see if cluster is ok all conections work check to make sure that the harness going into cluster is fitted correctley also check does it have two fog lights as most cars only have 1 and the other is a dummy one with a spair bulb if not you can do a splitter wire from the other side to make the light work hope this makes sence ivan uk

Oct 06, 2012 | 2005 Renault Scenic 1.6

1 Answer

Changing the headlights


Try not to touch the buld as you do the installation. There is a access cover in the back of the head lamp. This gives you access to the headlamp. Now when you get to the light buld and socket turn counterclockwise.Then the light bulb wil come out of its socket.From here disconnect the electrical connection.Now for the installation connect the electrical socket to the headlamp bulb.Install the buld in the socket,by rotating socket clockwise locking the retaining tabs to the housing,install cover test the light and you are done2_29_2012_7_31_02_am.gif

Feb 28, 2012 | 2004 Chevrolet TrailBlazer

1 Answer

Whats the size of the small projection light inside the inside corner of the headlight?


If this is the light thats on with the parking lights or the headlights on or the day time running light? a 3757 NAK is an Amber daytime rnning light and a clear daytime running light is a 3157K, both are right depending on your car. ( the cars made both ways depending on if it's a base model or not and did it come with optional headlights ( three options)). Then their are the headlights themselves as their are 6 possibilities. Easiest way is to remove the buld and read the number off or it or lay it on the counter of the auto prts store and let them match it up. A 3157 is a big bulb a dim marker light is a 194 and a bright marker light is a 921. Theres a fog driving light thats an H3, Small and very bright. Base model with HID low beams ( bright blue/white ) cost me $135 each and have a ballast attached ( my strore has them in stock) and up model has H1115 low beams. The bulb your asking about is likly to be the fog driving light and it's a H3

Jan 31, 2011 | 2006 Cadillac STS

1 Answer

Acura T.L 3.2 2002, my left headlight stop coming on. Replace HID buld low beam. Didn't work right so I switch bulds right to left still only the left drivers side headlight won't come right on. Sometimes...


I having a same problem as you.
I have changed Head light (general head light 12V 37W)
I plug out inverter connector and connect 12V 37W bulb directly
It works fine.

Oct 26, 2010 | 2002 Acura 3.2TL

1 Answer

HOW DO YOU CHANGE THE BULBS OF THE FOG LIGHTS?


The fog lights on most vehicles sit directly underneath the headlight bulbs. The ballast and wiring work just like the headlights, so changing them takes not much time. The procedure to change the fog light is as follows:-- 1) Open the hood and reach down underneath the headlights to unplug the electrical plug from the fog light assembly. Squeeze the top of the release tab and pull the connection off the bulb's ballast. 2)Turn the fog light counterclockwise to remove it from the fog light housing. 3)Install the new fog light bulb.Then connect electrical plugs properly. 4) Test the fog lights by turning it ON. Thanks. you can rate this solution and show your appreciation.

May 20, 2010 | 2002 GMC Yukon XL

1 Answer

How do u change a bulb in the fog lights on a


The fog lights on most vehicles sit directly underneath the headlight bulbs. The ballast and wiring work just like the headlights, so changing them takes not much time. The procedure to change the fog light is as follows:-- 1) Open the hood and reach down underneath the headlights to unplug the electrical plug from the fog light assembly. Squeeze the top of the release tab and pull the connection off the bulb's ballast. 2)Turn the fog light counterclockwise to remove it from the fog light housing. 3)Install the new fog light bulb.Then connect electrical plugs properly. 4) Test the fog lights by turning it ON. Thanks. you can rate this solution and show your appreciation.

May 20, 2010 | 2003 Ford Focus

1 Answer

How do I get to the bulb on a 2006 hhr to change it?


I am assuming you mean the headlight buld since they are the toughest. The procedure is in the owners manual, but it is not easy. You need to turn the wheels in (to right for drivers side) and then shut car off. Then you will need to loosen the inside front wheel well, which is plastic, until you can bend it out of the way enough to reach inside to the bulb. The bulb twists out with a 1/4 turn to the left and then unplugs. Just a hint, make sure that the gasket comes out with the bulb and that you only use one when you reinstall the new bulb. Fog light bulb is replaced the same way.

May 14, 2010 | 2007 Chevrolet HHR Special Edition

1 Answer

I hae a 2004 GMC and the passenger side fog light does not work but the driver side works properly. It is not the buld as I switched from left to right light it made no difference. The wiring seems to be...


could be the socket check to see if there is any rust in the bulb socket nthat has been a known issue for GM fog lights. If so you will have to change the whole light.

Oct 27, 2009 | 2003 GMC Sierra

1 Answer

How to change fog lights bulbs on my 2005 honda


548ae69.gif
  1. Remove the fog light mounting screw.
  2. Disconnect the connector from the fog light.
  3. Turn the socket about 45° counterclockwise and remove it from the housing.
  4. Remove the bulb from the socket.
To Install:
  1. Install the bulb in the socket without touching the glass with bare hands.
  2. Turn the socket about 45° clockwise to install it.
  3. Connect the connector to the fog light.
  4. Install the fog light mounting screw.

Jul 14, 2009 | 2005 Honda Odyssey

Not finding what you are looking for?
2004 Jeep Grand Cherokee Logo

460 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...