Question about 2006 Chevrolet Monte Carlo

1 Answer

Power loss, had car jumped allowed for it to run idle. shut it down for a min. power loss again. what is it?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 246 Answers

It could be your battery or alternator,have them cheked for voltage and for a draw in the system.there is an easy way to see if you alternator is the problem,start the car and disconect one of the battery poles,if the car dies out then your alt. is no good.

Posted on Sep 10, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

410 g loses all hydrolics and wont move after 10 min of opperation and will work after i shut it off for 5 or 10 min


check for correct oil level in the transmission
to much oil = frothing which= loss of pressure
shutting down allows the air to come out of the oil and so it works again

Jul 22, 2015 | Cars & Trucks

1 Answer

2000 blazer idles 5-15 min. Shuts off restart in mayb 5 min.


First, why are you allowing engine to idle for such long times? Heat in electronic components can build to excessive levels when idling. Coils, ignition modules, crank and cam sensors all can fail at these times. Once part cools it may function again.

Jun 25, 2015 | Cars & Trucks

2 Answers

1998 ford explorer 4.0 v6 idle


run fault codes and look for faults in idle sensor---MAF sensor

Aug 17, 2013 | Ford Cars & Trucks

1 Answer

I changed the engine oil, filter and spark plugs in my 1999 Volvo 940 (1996 cc). Upon starting up, the engine runs at lower rpm and "hiccups" at idling.


Engine stalls or RPM fluctuates at idle up and down.

This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve but always run a OBD2 fault code as well as the cleaning procedure. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control


Oct 15, 2012 | Cars & Trucks

1 Answer

1994 f150 6 cyl engine shuts down every 10 min restart after 5 min


Sounds like the module inside the distributor. Have to be replaced.

Sep 29, 2012 | Cars & Trucks

1 Answer

Timing chain possible jumped tooth


yea sounds like a belt or Chane but dose not jump going down the road much most of the time will do it when u start the car..

Jun 17, 2012 | 1987 Toyota Pickup

1 Answer

No power to dash or dome light in 2003 jeep tj.


As far as the guage issue it is most likely a problem with the body control module, have a trouble code test run on the BCM to determine the issue, the stalling is caused by the loss of the idle strategy learning when the battery went dead, the best thing to do is the following procedure I use to clear this issue.

Here is the most common cause of surges and stalls (or very low idle) near or at idle, it is the idle speed control air-bypass valve and throttle valve, they get full of gunk over the miles and cause idle issues (stalls) like yours, Get a can of intake cleaner from any local parts store, not carb spray, intake cleaner, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 minutes, then restart and complete a number of mixed driving cycles, town, freeway, stop and go etc., after a few days the problem will go away as the system will relearn to the clean intake.

Nov 20, 2008 | 2003 Jeep Wrangler

Not finding what you are looking for?
2006 Chevrolet Monte Carlo Logo

Related Topics:

56 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...