Question about 2006 Land Rover LR3

1 Answer

How do you get the steering wheel off a land rover discovery 3

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Land Rover Master
  • 22,326 Answers

With great difficulty,first you have to disconnect battery to stop air bag accidently going off ,then remove the air bab ,two clips underneath steering wheel ,very difficult without the right tools ,then the big nut and maybe evan a steering wheel puller.Whats the fault that necessatates removing the steering wheel in the first place?

Posted on Sep 10, 2009

  • dre450yfz Jul 14, 2010

    There are no bolt holes for a steering wheel puller. A fly wheel puller will work .



6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 218 Answers

SOURCE: Radio in 2000 Land Rover Discovery


Posted on May 15, 2009

  • 1 Answer

SOURCE: Land Rover Discovery TD5 1999. Where is the Fuel Relay Switch

In the engine fuse box under the bonnet ,relay is the closest one to the front of the vehicle ,about £7 to replkace

Posted on Jun 09, 2010

  • 3 Answers

SOURCE: Land Rover Discovery I dashboard replacement.

There is a little more to it than that, but not a tough job if you have patience. You will need to remove both 'doors' on the dash-one glovebox, one fuse access panel. on US models, you will need to remove the pass side airbag as well, then 2 bolts that hold a set of relays under the airbag, then 5 bolts that hold a support bracket (also under the pass side airbag-behind glovebox.

Then under the dash at teh outside near the doors, remove 2 sets of 10mm bolts. after than remove 2 sets of 10mm bolts near where the bottom of the dash touches the tranny tunnel. obviously all the center console needs to be removed, and the center panel of the dash, as there are several sets of screws that hold that to the back of the dash.

be patient, take lots of photos of how it goes together, and where the wiring is(was), and this is pretty easy.


Posted on Jun 10, 2010

  • 1033 Answers

SOURCE: land rover discovery 1996 V8i engine firing order


Posted on Jun 22, 2010

  • 5 Answers

SOURCE: 2009 Land Rover Discovery and Blackberry Curve 8900

You'll have to call the dealer have them pull the VIN to see if you have the latest and greatest software. Also you can check on the land rover website under owners put in the last 8 digits of your vin number and it will tell you if the BB8900 is fully compatible.

Posted on Aug 15, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

My 1999 land-rover discovery is vibrating at 60-80,had the tyres checked all good, any thoughts ?

Depending on the vibration the speed you mention is when drive shaft vibrations are evident. Check all "U" joints for wear,check slip joints for wear especially the front shaft.Check wheel alignment for castor problems and check the steering shocky ( if fitted)

Nov 04, 2014 | 1999 Land Rover Discovery

1 Answer

The steering damper on my 1997 land rover discovery is broken. the replacement part is on back order. can i drive it until the part arrives?

It certainly can be driven, but when going over bumps, the steering wheel will jump around in your hand a bit. I would advise not replacing with a factory OEM damper as companies like ARB make a much heavier dirty model and will last and work a lot better

Apr 02, 2012 | 1997 Land Rover Discovery

1 Answer

What kind of steering fluid does a 1998 land rover discovery take?

It uses hydraulic power steering fluid NOT aft! - download this (Free Rave manuals - Rover Bible) -

Mar 24, 2011 | 1998 Land Rover Discovery

1 Answer

I have a 2002 land rover discovery and the horn appears to be stuck but I don't know where. I had to take off the fuse to stop the horn blowing. What should I do?

Actually the horn buttons on the steering wheel break routinely, Un jam the button and replace it, You have to be brave though as the airbag has to be disconnected to remove the steering wheel

Nov 11, 2010 | 2002 Land Rover Discovery Series II

1 Answer

Where is the heater core located on a 2002 discovery series 2 land rover??

It sits behind the dash, and is a real pain to replace. It's a dash-out job I'm afraid, along with removing the radio, steering wheel, centre console and nacelle.

Dec 08, 2009 | 2002 Land Rover Discovery Series II

1 Answer

I have a 1996 Land Rover Discovery XS TDI. There is play in the steering which is becoming worse with a clunking sound. I am looking for parts and am not sure which part I need to replace. Any ideas how...

you've got to jack the vehicle up and rock the tire/wheel assembly back and forth from right to left, as if being turned by the steering wheel while you look to see which joints are loose. if there's clunking, it will be very loose and obvious just by looking. sometimes though you've got to put your hand on the joint to feel for play.

Sep 26, 2009 | 1996 Land Rover Discovery

Not finding what you are looking for?
2006 Land Rover LR3 Logo

565 people viewed this question

Ask a Question

Usually answered in minutes!

Top Land Rover Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

79847 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Land Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides