Question about 2000 Mazda Protege

Open Question

Mazda protege2000 1.6 liter cranks then runs for about a3minutes then chokes out

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My truck mazda 1995 b2300 2.3 liter had recently


Have you checked to see if you have good compression in all 4 cylinders ?

Sep 17, 2014 | Mazda B2300 Cars & Trucks

1 Answer

HOW DO A CRANK SENSOR LOOK ON A MAZDA PROTEGE?


check this out on autozone.com web site at plus it depends on the liter of engine but you ca add your liter engine but here is one on there web site at : http://www.autozone.com/autozone/parts/1995-Mazda-Protege/Crankshaft-Position-Sensor/_/N-j1kmtZ8znbj?filterByKeyWord=crank+sensor&fromString=search

Jun 02, 2011 | 1995 Mazda Protege

2 Answers

My car turns over good, acts like it might turn on then continues to turn. I figure it might be fuel filter since low fuel light had come on.Or could it be th fuel pump got hot and is not working properly?


common problem is turning car off with engine not reaching normal operating temp and floods engine. try this. DE-CHOKING PROCEDURE WHEN ENGINE CRANKS BUT DOES NOT START
If the engine does not start, try the following procedure to start the engine using the de-choke mode.
Failure to do so may aggravate the no start condition.
1. Depress and hold the accelerator pedal to the floor and crank the engine for 7-8 seconds. (This will clean out any unburned fuel from the combustion chamber)
2. Release the ignition key to stop cranking.
3. Release the accelerator pedal and start the engine. If the engine starts while performing Step 1 the engine will rev up. Immediately release the ignition key to stop cranking and remove your foot from the accelerator pedal.
^ Do not keep holding the ignition switch in the START position over 10 seconds if the engine does not start. This may result in a weakened or dead battery.
^ Avoid racing the engine or sudden take off right after starting the engine.
^ If the engine still fails to start following the De-choking procedure, have your vehicle inspected by your Mazda Dealer.

for your info there is a recall for this problem. contact mazda.

May 04, 2011 | 2004 Mazda RX-8

2 Answers

Hard starting when cold ( engine cranks normally )


see if your engine has a ECT sensor (temp sensor that delivers information to your ECM) they are installed on the intake side of the cylinder head, it usually has 2 cables, have it checked replace if necesary

Nov 19, 2009 | 1991 Jeep Wrangler

1 Answer

1996 mazda mx3 precidia, extremely hard to start


Before you spend the time and money,get the auto choke checked.It may make the car hard to start.Basics 1st.Hope this helps

Aug 18, 2009 | 1995 Mazda MX-3

2 Answers

Firing order 1987 mazda b22


You didn't put your engine size so choose the one that is applicable:

1987 Mazda B Series Truck
2.0 liter L4
007217f.gif

1987 Mazda B Series Truck 2WD
2.6 liter SOHC L4

61aa395.gif
1987 Mazda B Series Truck 4WD
2.6 liter SOHC L4


bce0551.gif

Jul 10, 2009 | 1987 Mazda B-Series

1 Answer

Battery dies while car is running


The alternator is what keeps your car running once it's cranked. It also recharges the battery for the next crank. It's either your alternator can't produce enough power to keep the car running. Your fuel filter is dirty. Your air filter isn't allowing air flow. If it sputters before it dies it could also be the O2 sensor.

Jun 05, 2009 | 1996 Mazda Millenia

Not finding what you are looking for?
2000 Mazda Protege Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8755 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...