Question about 2006 Land Rover Freelander

2 Answers

How do I change Rear Breaks on 2006 LR3 Land Rover- step by step please

Posted by on

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 333 Answers

Brake Pads

Service Repair No - 70.40.03


Removal

  1. WARNING: Brake pads must be renewed in axle sets only, otherwise braking efficiency may be impaired. WARNING: If the brake pad wear warning light has been activated, the pad wear sensor must be replaced. CAUTION:To avoid accidental operation of the Electric Parking Brake (EPB) andpossible damage to the EPB actuator, remove Fusible link 8, located inthe engine compartment fuse box before commencing work. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands. Raise and support the vehicle.
  2. Remove the wheel and tire.
  3. CAUTION: The brake pad wear indicator sensor is easilydamaged. Do not use a lever to remove the sensor. Use fingers only. RHside only: Disconnect the brake pad wear indicator sensor.
  4. Remove the brake caliper lower bolt.
  5. Remove the brake pads.
Installation

WARNING: Do not use compressed air to clean brake components. Dust from friction materials can be harmful if inhaled.

Clean the caliper housing and anchor plate using brake cleaning fluid.
  1. Inspect the caliper piston and slide pin seals for damage.
  2. Position a bleed jar containing a small quantity of approved brake fluid. Connect the bleed tube to the bleed screw and loosen the screw.
  3. Press the piston into the caliper housing.
    • Tighten the bleed screw to 14 Nm (10 ft. lbs.) .
  1. Disconnect the bleed tube and remove the jar.
  2. Install the brake pads.
    • Install the 2 clips.
  1. Rotate the brake caliper downwards.
    • Tighten the bolt to 35 Nm (26 ft. lbs.) .
  1. Connect the brake pad wear indicator sensor.
  2. Repeat the above procedure for the other side.
  3. Install the wheels and tires.
    • Tighten the wheel nuts to 140 Nm (103 ft. lbs.) .
  1. Depress the brake pedal several times, check the fluid level in the brake fluid reservoir and top up with brake fluid if necessary.

Posted on Sep 10, 2009

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,533 Answers

Try these websites www.autozone.com and www.alldatadiy.com if all fails stop by your local library and get your hands on a Haynes auto repair manual for your SUV wish you the best of luck Michigan Man.

Posted on Sep 10, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Should i buy a 2006 land rover lr3 se with 140000 miles


Life car is about 225000 km.You have 224000 km.Think about.

Mar 16, 2013 | 2006 Land Rover LR3

1 Answer

How to change the battery on a 2006 Land Rover LR3 remote


most plases that sell watches and stuf should be abel to chang it for you

Jan 17, 2013 | 2006 Land Rover LR3

1 Answer

The engine ship came on?land rover LR3 / 2006


That little ship means you are low on coolant, check the overflow bottle for the antifreeze.

Nov 04, 2010 | 2006 Land Rover LR3

1 Answer

High spots on rear rotors on 2005 land rover lr3


each rotor has a machine limit expressed in thousanths of an inch, you would have to remove them and take them to a machinist, have them measured with a micrometer and he can tell you yes they can or no they can't

Mar 30, 2009 | 2006 Land Rover LR3

Not finding what you are looking for?
Cars & Trucks Logo

590 people viewed this question

Ask a Question

Usually answered in minutes!

Top Land Rover Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

yadayada
yadayada

Level 3 Expert

76630 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8516 Answers

Are you a Land Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...