Question about 1998 Chevrolet S-10 Pickup

1 Answer

Are s-10 wheels universal with any year

Are chevy s-10 wheels universal with any year

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 22,219 Answers

Should think so ,but make sure that what you put on conforms with fiche technica the technical specifications or you could face a big fine and points on your licence

Posted on Sep 10, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I need scamatic for chevy s-10 4 wheel drive vacuum hoses


post the year and engine size. I may be able to help you

Jan 03, 2015 | Chevrolet S 10 Cars & Trucks

1 Answer

I have a 07 Chevy cobalt my front tires seem to big the inside wear like there rubbing on the stut tire size is "225/40R18"


Hi Kyle,

Just had mine done on My 10 year old Mercedes. Steering Rack Gone had to replace. Need to have laser tracking as I have modified wheel rims which cannot be traditionally tracked. Good Luck,


Jack:}

Nov 17, 2012 | Cars & Trucks

1 Answer

Four wheel drive does not seem to engage when shifted into 4 high or 4 low


disconnect your battery for 10 minutes and try it again. i had the same problem years ago with my chevy and it seemed to work.

Jun 17, 2011 | Dodge Ram 2500 Cars & Trucks

1 Answer

No Fuel To Throttle Body On A 1991 Chevy Blazer S-10, 4.3L


ok, well as for the relay, yes there is one in your under hood fuse box....or inside the drivers door...but if you don't hear the pump, fear the worst, it may be dead.....happens ALOT.....check and change the relay, about $10, then if nothing, time for a new pump.

Feb 15, 2010 | 1991 Chevrolet S-10 Blazer

1 Answer

Will the bolt pattern on rims off a 98 Jeep Wrangler fit on a 98 Chevy S-10


Sorry no they won't fit. S10 are 5 on 4.75 positive offset. You can put older wheels from many older chevys on them but they will stick out of the wheel wells if you have 4x4. The Wrangler are 5 on 4.5 negative offset.

Nov 04, 2009 | 1998 Chevrolet S-10 Pickup

1 Answer

Wheel bearings on 1988 chevy S-10


remove grease cap,brake caliper, then remove nut holding rotor now remove rotor, remove grease seal now both bearings should be out ,if replacing races then punch them out and tap new ones in, repack new bearings with grease install rear one and install new grease seal, slide rotor on slide frt bearing on, install washer and nut, tight a little to nearest cotterpin hole,put cotterpin in and put caliper on, hope this helps,good luck.

Oct 27, 2009 | 1988 Chevrolet S-10

1 Answer

There is a vibration in my 1998 Chevy S10, 4 cyl., 5 transmission truck when I shift into 3rd gear. The vibration lasts until I reach about 38 MPH and then stops. There is also a clunking sound when I...


well i would check your universal joint's put the parking brake on and block the wheels put the car in n and reach under truck and see if there is play in universal if so need replacement if you have two peace drive shaft check your center support bearing good luck if these check good it could be in transmission good luck redoil

Aug 06, 2009 | 1998 Chevrolet S-10 Pickup

2 Answers

Steering knock/pop while turning on 2005' chevy


sounds like a steering column universal gone bad try shaking wheel while in park an look under hood at steering shaft

Aug 05, 2009 | 2005 Chevrolet Malibu

1 Answer

Squeaking Noise in 2003 Chevy S10 Engine 2.2


this would not be a wheel bearing, it sounds like a driveshaft universal joint noise.

Feb 23, 2009 | 2003 Chevrolet S-10

Not finding what you are looking for?
1998 Chevrolet S-10 Pickup Logo

Related Topics:

60 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...