Question about 1991 Chevrolet S-10

1 Answer

Will a dash wiring harness for a 97 s10 blazer work on a 91

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 74 Answers

No it won't differnt computers with differnt plugs, and no you can't use the 97 computer, because the engine won't run right

Posted on Sep 10, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 97 S-10 Blazer fuel guage wont work


Likely, it's the sender unit in the tank. To check wiring and your dash gauge, you can pull apart the connector at the fuel tank, find the wire for the gauge sender unit (its color coded-I dont kinow what the one for your car would be), and on the harness side(the one going to front of vehicle) use a jumper wire and ground that wire to the car frame(get me? you want to ground the wire going to your dash gauge)-with key on, your gauge working properly will move up to half-way or even full. That tells you your dash gauge is working and your wiring to gauge is good. If gauge doesn't move when grounded(double check for a good ground), then your dash gauge may be bad.

Oct 12, 2011 | 1997 Chevrolet Blazer

2 Answers

Where Is The Turn Signal Flasher Located At On A 1995 S10 Blazer


To Remove:
  1. Open the glove compartment.
  2. Lift the tab to allow the glove compartment to swing down.
  3. Use a flat bladed tool to release the flasher from the harness connector.
  4. Remove the flasher.
To Install:
  1. Connect the harness connector to the flasher.
  2. Secure the flasher with the retainer.
  3. Swing the glove box up to the normal position.

tecnovative_72.gif

tecnovative_73.gif

Jan 31, 2011 | 1995 Chevrolet Blazer

1 Answer

Where is the idle air sensor or the throttle position sensor on a 97 s10 blazer


look directly on the throttle body close to the linkage for the gas pedal it will be in that general area. look for a wire harness.

Jul 30, 2010 | 1997 Chevrolet S-10 Pickup

2 Answers

Will the fuel pump out of a 97 s10 work in a 91


check fuel pump relay first and yes it will

Oct 12, 2009 | 1991 Chevrolet S-10

1 Answer

91 chevrolet s10 blazer heater core access?


not really. IT is under the dash on the passenger side. You should put some plastic down or pull the carpet or it will get soaked with anti freeze

Oct 01, 2009 | 1991 Chevrolet S-10

3 Answers

1991 Chevy Blazer dashboard lights are burned out. Can't read


Your dash needs to come out. These bulbs push into a plastic piece that "twists" into the back of the dash board. (About a 1/4 turn) Unless you can get at them from underneath, but I think it's to tight.

Aug 13, 2009 | 1989 Chevrolet S-10 Blazer

1 Answer

1991 S10 blazer tail lights dont work


i own a 1991 chevy blazer myself but my problem is opposet of yours my back lights stay on well i went underneath the dash board an i look up underneath my steering column an i saw to components one was to my cruise control an the one in back of it was to my back lights an i moved this around an to my surprise my light swork good now but now my speed odometer doesnt not work an my gas gauge am my oil aa water gauge my power windows dont work an niether my a/c or heater defroster im jus wondering if i need to move this component alittke more to the left or right yesterday everything worked hmmmm

May 18, 2008 | 1991 Chevrolet S-10 Blazer

Not finding what you are looking for?
1991 Chevrolet S-10 Logo

Related Topics:

136 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6910 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...