Question about 1990 Jeep Cherokee Limited

1 Answer

What are the steps to replace a headlamp in a 1990 jeep cherokee larado?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Jeep Master
  • 6,982 Answers

Remove the plastic trim cover around the light, then remove the four screws that hold the stainless steel ring that goes around the light. Don't turn the two screws that are not attached to the ring (center at top or bottom, other on outboard side in center)...they adjust the aim. I suggest you spray solvent on the screws as they nearly always get stuck. Sometimes you will need to tap on the back of the screwdriver with a hammer to loosen them as well. Use some white lube on the connector spades so they can easily be removed the next time as they often corrode and make plug removal difficult.

Posted on Sep 10, 2009

Testimonial: "Thanks so much!!"

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hi, i have a 2001 grand jeep cherokee 6 cylinder larado, the car is not running hot, the fan won't stop running, i was told to disconnect the battery cable which i did so do i need a new fan?


you probably have a bad solid state fan relay. This is a very common problem with jeeps. You'll love where they put this one. It is located under the passenger side headlamp assembly, but wait it gets better. The entire front headlamp grill support needs to be removed in order to gain access to the relay. The good thing is there is a shortcut that involves cutting a small hole in the headlamp/grill support under the passenger side headlamp assembly. I have a photo that shows where to make the hole and can post it if your interested in trying to tackle this yourself.

Sep 08, 2011 | 2001 Jeep Grand Cherokee

2 Answers

How do I remove a radiator in a 1999 jeep grand Cherokee larado


follow this link, it goes step by step. good luck and be patient, i hate replacing rads. I buy a lot of band-aids.
http://www.ehow.com/how_4508508_replace-radiator-jeep-grand-cherokee.html

May 19, 2011 | 1999 Jeep Grand Cherokee

1 Answer

Hi i have a 1990 jeep cherokee pioneer 4x4 the dash lights are not comin on and neither are the break lights how do i fix this i already replaced the fuses and the headligh switch


i have an 89' cherokee. i had the same problem. first my headlamps didnt work, so i replaced the (pull) headlamp switch on the dash. well, then my dash lamps and break lamps didnt work. i returned the headlamp switch and found out that it was defective. try to get a new headlamp switch and make sure that all the male ends are straight up and down. the defective one i got had one bent male end on the opposite end of where the pull knob goes! watch out for that! i hope this helps.

Aug 23, 2010 | 1990 Jeep Cherokee Limited

1 Answer

2001 jeep gd. cherokee larado 4.0 4wd auto. when


Have you run an engine control system fault code test? If not do that first.

Jun 08, 2017 | 2001 Jeep Grand Cherokee

1 Answer

How do u take off water pump to replace on 1990 jeep cherokee larado


Hi,
This would be a lengthy reply. My best advise I can offer you, especially if you plan on keeping this vehicle a while, is to get a cheap repair manual from your auto parts store. Though around 20 or so bucks, it will guide you step by step for the removal and installation of the water pump. Plus it could come in handy for any other future job you might need to perform on the Jeep.
I hope this helps... Good luck with your project!

Oct 13, 2009 | 1990 Jeep Cherokee Limited

2 Answers

My 1990 jeep cherokee dash lights fuse blows


YOU HAVE A BARE WIRE THAT IS MAKING CONTACT ON SOME METAL CAUSING IT TO SHORT OUT . FOLLOW THE WIRE FROM THE FUSE AND CHECK FOR A BAD SPOT ON THAT WIRE. GOOD LUCK!

Jun 10, 2009 | 1990 Jeep Cherokee Limited

Not finding what you are looking for?
1990 Jeep Cherokee Limited Logo

Related Topics:

35 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...