Question about 1993 Jeep Grand Cherokee

2 Answers

93' Grand Cherokee, dont start, no spark,no gas preassure

I was running my Grand Che.93' when I run over a few bumps in the street, it stops the engine

Posted by on

  • jparis7549 Sep 10, 2009

    No diagnosed

  • jparis7549 Sep 10, 2009

    I change the Crank sensor, verify the ASD relay,and verify the voltage when starts & it drops to 10.5 volts,

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

My 1996 jeep grand cherokee lmtd. won't start did tune up. cranks but no fire. please help. engine code 54 shows up . cam shaft positioning no signal. . tested all circuit. changed cam shaft positioning sensor twice.still cranks did start once ran for 5 min. changed the sensor again. no luck. help please. keith

Posted on Sep 13, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,280 Answers

Amazing!.. .did you take it in to have it diagnosed?

Posted on Sep 10, 2009

  • PAUL MC G
    PAUL MC G Sep 13, 2009

    Perhaps you should. The possible causes are numerous... most suspected is 'electrical' because it happens when you hit bumps.... loose wiring/connections

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Jeep starts but immediately dies off


run fault codes and check for MAF/MAP and VAF sensor problems

Feb 22, 2014 | Jeep Grand Cherokee Cars & Trucks

2 Answers

93 jeep grand cherokee wont start


Take 2 screws out of PCM and replace with shorter ones

Oct 23, 2012 | 1997 Jeep Grand Cherokee

1 Answer

93 jeep cherokee 4.0 dies when stopping but idle till fuel gone


GREAT INFORMATION...

however, you were not clear about fuel pressure

was fuel pressure OK before and during the concern...30psi and have you check flow

PLUS...during the concern are you loosing SPARK? Coil is great suspect!

while the code for the crank sensor concerns me I'd start with the most common Jeep concern...the ASD (auto shut down realy)

when you start testing again remember to check the CKP output at the sensor and the CKP input at the computer...you might have a CKP circuit that is worn out







Apr 06, 2010 | 1993 Jeep Grand Cherokee

1 Answer

93 jeep grand cherokee. just got it running and the engine is running really rough how do I get it to run smoother. It has fresh gas but am worried it sat too long! 8 moths or so. Also the oil pressure...


If you worried about your gas, put in a bottle of sta-bil or ISOheat. This will remove all water and condensation from the gas. I would also replace your fuel filter, spark plugs and WIRES. Check for any vacuum hose leaks, if needed do compression test to verify that your gaskets aren't leaking.

If you have service/check engine light on, have a diagnostic test done to pinpoint the bad sensor or circuit that is setting it off.

Nov 17, 2009 | 1993 Jeep Grand Cherokee

1 Answer

1995 jeep grand cherokee laredo. Gets the death wobbles when going 50 or faster and hit a bump. Have to hit the brakes to make it stop.


Front shocks/struts may be shot...not dampening the blows from the street.
Also...very important... wheel balancing. Wheels that are out of balance will start bouncing like this too.
Also check alignment if it's only when you hit a chuck hole.

Jun 08, 2009 | 1995 Jeep Grand Cherokee

1 Answer

93 Jeep Grand Cherokee Won't start


The crankshaft position sensor was seriously problematic in those old jeeps. It's located towards the top of the bell housing slightly to the driver's side I think.

Apr 15, 2009 | 1994 Jeep Grand Cherokee

2 Answers

'93 Grand Cherokee intermittently starts and runs


Hi, I had simmilar problem with my 1993 JGC . I ran out of gas and it would not start until the next day. Then it will start and run until I put the brakes on tho stop and then it will die. It starts right back up. Ended up being the voltage regulator in the ECC/ECM. It is at the mechanics shop right now waiting for the ECC to come in.I will post a follow up.
have Fun,
David C

Oct 15, 2008 | 1993 Jeep Grand Cherokee

Not finding what you are looking for?
1993 Jeep Grand Cherokee Logo

592 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...