Question about 1993 Jeep Wrangler

1 Answer

2007 wrangler rubicon 4wd

2007 wrangler
starts but does not come out of gear and no guages work, fuel guage, rpm guage, none come on and it rained all day yesterday, any ideas what this problem might be

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 295 Answers

There is now bus signal to the Insturment cluster I have seen this before. Unplug the Insturment cluster and plug it back in this will reset the computer it should communicate with the Can C bus and should come out of gear. Keep in mind if this works it is only a temporary fix. Hope this helps please rate if it does.

Posted on Sep 10, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

REMOVING STOCK SHIFTER FOR 4X4 ON 07 WRANGLER


The 4WD shifter knob on the 2007 JK's is ridiculously hard to remove. Pull straight-up with all your might, then after that fails, get some towels, and a chunk of would with a long pry bar. Hopefully you won't crack your center console.

Mar 19, 2014 | 2007 Jeep Wrangler Unlimited Rubicon 2...

1 Answer

Low fuel light on gauge doesnt work


lamp burned out, ?
but does the fuel guage work 100%
and at what tank level do you expect the lamp to come on.?
did you read the FSM on this, its covered
or alldata.com?
free.
http://www.jeep4x4center.com/knowledge-base/index.htm?utm_source=cj#service

on this car, the PCM reads the fuel level then sets the fuel guage
and if the level (voltage from tank sender) is below a specific
voltage , it glows the lamp, low fuel
so if the fuel guage works, and the lamp is dead, the lamp is burned out. (or conn. bad to it)

Jan 24, 2014 | 2002 Jeep Wrangler

1 Answer

2007 F350 4x4 regular cab V10 gas guage quit working I had the sending unit and fuel pump changed the fuel guage went to 1/4 and sat there. Any tips? Fuel guage wont work.


I'm assuming this has dual tanks, do you know if it is not working on both tanks ?
Most people would check the circuit for the gauge at the tank. The sending unit grounds the gauge on the dash.

Aug 31, 2012 | 2007 Ford F-350 Super Duty XLT

1 Answer

97 Jeep Wrangler sport- Cranks, will not


Fuel flow. Either simply, a blocked fuel line (debris / filter / fouled gas) or an electronic issue. Ever let this Jeep run bone dry on gas? Hopefully not, as doing so can draw a lot of crud into your fuel lines from the bottom of the tank. Electronically, if part of the Jeep "brain" has gone bad, there may not be any fuel being routed to the engine. This most likely needs a Jeep mechanic to repair.

May 15, 2010 | 2007 Jeep Wrangler Unlimited Rubicon 2...

2 Answers

Water leak to floorboard on drivers side. Carpet wet all the time with standing water. My Jeep is a 2007 Wrangler/rubicon


It it happens when it is raining. This seems to be a common problem with Vehicles.

There is a seal on the passenger side Hood Hinge area. If this seal is cracked or broken or missing you will get water in the car every time it rains.
The water runs down the windshield in to the Hing area under the Hood.

You may need to take the hood off to get to the seal. First pour water over the area, if it comes in the car there is your problem.

You can seal it with any water proof silicone sealer .

Nov 10, 2009 | 2007 Jeep Wrangler Unlimited Rubicon 2...

1 Answer

Gas guage and water temp gauge do not work clock works alt works oil works guages work just not gas and water temp ?????


On the rear of the instrument cluster there should be a resistor. This is how the fuel and temp guages are limited to a certain voltage decreasing the power to them so that they dont burn out. These (voltage limiters) resistors are available seperately from the dealership.

Oct 04, 2009 | 1987 Jeep Wrangler

1 Answer

Guages not working fuel guage temp. guage rpm guage i don't know what fuse to look at


your fuses are located on the divers side when you open the door, just pull the panel off & on the back of it should tell you exactly what fuse to look for...

Jul 10, 2009 | 1994 Dodge Intrepid

1 Answer

1997 2.5L CRANK NO START


clog in your fuel line or you need to change your fuel filter.

Jul 09, 2009 | 1997 Jeep Wrangler

2 Answers

Fuel gauge does not work checked fuses none bad


first start with the cheapest parts like the guage itself.may need replacing.if thats not it could possibly be a wiring problem.also check the float in the fuel tank.

Dec 01, 2008 | 1994 Mazda 2WD B Series Pickup

Not finding what you are looking for?
1993 Jeep Wrangler Logo

Related Topics:

109 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...