Question about 2005 GMC Sierra

1 Answer

I want to install cruise control on my 2005 gmc sierra 4x4,whats involed?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 47 Answers

Hi,

Most of the time cruise controls are one of the easier accessories to install into a vehicle. Most only take approx 45 minutes to install. Some may take longer. Vehicles with manual transmissions may add another 10 minutes to the job on average. There are usually only six electrical connections and only two mechanical connections to make when installing a cruise control into a gasoline (not diesel) powered vehicle with an automatic transmission as well as mounting the control arm and servo.

Cheers,
Kanu

Posted on Sep 09, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Can I see images of where the plug is under hood for Cruise control connection on 2005 GMC?


Here watch this video , yea yea I know this is a BUICK but your cruise is the same . The cable needs replacing , more then likely ! The control module for yours is in or near same spot as the Buick according to service info . No Cruise Control Buick LeSabre

Sep 14, 2016 | 2005 GMC Sierra

1 Answer

Need location of cruise control image for 2005 GMC. Turns off when hits bump.


Do you have a air bag light on the dash ? Check ground circuit for lose connection . Ground G203
In the I/P harness, on the left side of the I/P near the A-pillar below the I/P top cover .

Sep 14, 2016 | 2005 GMC Sierra

1 Answer

Will a 2004 1500 cheverlet rear end fit a 2007 gmc 1500 sierra


2 wheel drive check dif numbers or 4x4 if 4x4 check dif numbers 4x4 must be the same numbers

Mar 08, 2015 | 2005 GMC Sierra 1500 Hybrid

3 Answers

I have a 2005 GMC Sierra. Afew years ago I started having trouble with the A/C fan. Found overheating at connections on control module. Jumped some wires and have every speed except highest. Was s


If you don't have wiring diagrams,can't read them,&
or work on your own vehicles & their technology,then
a repair shop or different dealer, is you only option,that
question you knew the answer to

Sep 07, 2014 | 2005 GMC Sierra

1 Answer

2005 Sierra 4x4 doesn't work, 4h light is on and stays on


My 2005 Sierra 4x4 did the same thing while running down the interstate on vacation. Scared me to death, thought it was going to shift into 4 wheel drive @ 80 MPR. Had to take to shop and they found a censor bad and they replaced it. Don't know cost, because truck was still under warranty.

Nov 22, 2012 | 2005 GMC Sierra

1 Answer

How to reset my 4wd light? I just installed my new 4wd buttons on my 2005 gmc sierra z71, and my 4wd light still comes on what should I do?


There is no such thing as a reset, if the light stays on a fault exists in the 4X4 control system, the control module has sensed that and turned the light on to alert you to the problem. It is likely that the power transfer case actuator motor is the problem or the wiring to it.

Dec 13, 2011 | 2005 GMC Sierra 1500 Hybrid

2 Answers

1990 GMC Sierra 1500 pickup. Windshield wipers, Cruise Control


May want to look at replacing the wiper circuit board.It is located on the firewall adjacent to the wiper motor and has a some what square black cover with 3 torx screws and wireing harness pluged into the side.We had a truck that every time you washed it the wipers would stay on until it dryed out.You can try removing it and spaying it down with contact cleaner just watch the brease on the two contact tips.Well hope this helps.

Feb 05, 2010 | 1990 GMC Sierra

1 Answer

Cruise control wont work


normally the brake switch is the issue with these trucks. it is located under the dash where the brake pedal meets the linkage to the brake booster.

Jan 04, 2009 | 1997 GMC Sierra

Not finding what you are looking for?
2005 GMC Sierra Logo

Related Topics:

256 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...