Question about 1994 Mercury Villager

1 Answer

Mercury villager 1994 washer pump not working

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Mercury Master
  • 4,369 Answers

The pump motor likely is bad. get a used washer fluid reservoir at a pick n pull yourself or at car-part.com. page with * is lowest cost.

Pump and Reservoir, Windshield Washer Removal

  1. Disconnect the battery ground cable (14301).
  2. Raise and support the vehicle.
  3. Remove the RH wheel (1007).
  4. Remove the RH front fender splash shield (16103). Refer to Section 01-02 for the removal procedure.
  5. Remove the windshield washer reservoir top bolt.

  6. Disconnect the windshield washer reservoir fluid level sensor electrical connector.
  7. Disconnect the rear window washer pump electrical connector from the rear window washer pump.
  8. Disconnect the windshield washer pump electrical connector from the windshield washer pump (17664).
  9. Place a suitable drain pan under the windshield washer reservoir (17618) and drain the washer fluid.
  10. NOTE: The rear window washer hose end is color-coded, matching the connector on the rear window washer pump. Match the colors to ensure proper installation.

    Disconnect the washer hoses from the windshield washer pump and the rear window washer pump on the windshield washer reservoir.

  11. Loosen the two windshield washer reservoir side bolts.
  12. Remove the windshield washer reservoir by sliding it out of the side slots.
  13. Remove the windshield washer pump.

    Installation
To install, reverse the removal procedure. Tighten the lug nuts (1012) to 98-118 Nm (72-87 lb-ft).

Posted on Sep 12, 2009

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 41 Answers

SOURCE: My 1999 mercury villager ac works in the front but...

it needs to have the rear expansion valve to be inspected for metal, if clean repl expansion valve and recharge a/c

Posted on Jul 10, 2010

michigan man
  • 3533 Answers

SOURCE: 1994 mercury villager

if the car is stilling running hot check the antifreeze overflow bottle for a crack and to answer your question start the car and get it to normal temp while it is still running you open the overflow bottle fill it to the cold mark and keep adding coolant until all the bubbles are out of the system and put the cap back on right away

Posted on Jan 29, 2009

  • 47 Answers

SOURCE: 1994 mercury villager fan not working

The fan is control by a thermostat.
When the radiator reaches about 200 degree F. it should turn on.
If it do not turn on then it either the thermostat is bad or the fan.
When you turn the air condition on then the fan should also turn on.
Start with the cheap part which is the thermostat.Then work for there.

Posted on Mar 10, 2009

  • 454 Answers

SOURCE: i need a belt diagram for a 1994 mercury villager

Look under the hood, usually a belt diagram on the emissions sticker (look near the top of the radiator).

Posted on Oct 07, 2009

SOURCE: I have a 1994 Mercury Villager Van. My

erase the trans code by disconnecting the battery for aminute . If the issue is still present after then your going to have to have it diagnosed. Most likely you have a trans solenoid issue.

Posted on Nov 24, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Gas is not pumping from tank of 96 mercury villager . new fuel pump


check fuel pump relay. Can you hear the pump humming for 5 seconds when you tutrn the key to ON?

go to yahoo group for villager quest owners

Sep 23, 2011 | 1994 Mercury Villager

1 Answer

Where is fuel pump located of 1994 mercury villager


In the Gas Tank.. it is electric. You will need a book if you are going to do this yourself.. the last time I had to replace a fuel pump was on a 95 Ford Contour.. It cost me $600.. if you know what you are doing go for it.. keep a fire extinguisher handy... remember the fuel system is under pressure.. I currently have a Caravan 93 and it uses the same fuel delivery system.. Jim

Jun 02, 2010 | 1994 Mercury Villager

1 Answer

How to remplace a wather pump in a 94 mercury villager


I have shop manual & wiring book for 94 Villager for $25 plus postage. Let me know if interested.

go here for help too. It's an all day job but you can do it. Need to note where each bolt goes cause some are different sizes.

http://groups.yahoo.com/group/villagerquest/

Mar 31, 2010 | 1994 Mercury Villager

1 Answer

How do I change a water pump for a 1994 mercury villager???


drain coolant first,take off serpentine belt loose 6 bolts on water pump take off water pump clean well,put new gasket than install new pump

Jan 10, 2010 | 1994 Mercury Villager

2 Answers

I need firing order for mercury villager 1994


it's 1-2-3-4-5-6.

#1 is on the passenger side rear and #3 & #5 are also on the back.

#2 is in front on passenger side. #4 & #6 are across the front.

go here for expert villager help.

http://groups.yahoo.com/group/villagerquest/

Jan 05, 2010 | 1994 Mercury Villager

1 Answer

1994 mercury villager has skip and engine service


Try disconnecting the battery for 2 hours. Then drive for 10 miles so the PCM can relearn. It may run rough for 10 miles.

If not ok, go to Villager website for expert team help free. Check files, ask questions

http://groups.yahoo.com/group/villagerquest/

Oct 31, 2009 | 1994 Mercury Villager

1 Answer

Fuel pump type and location


if it is a intank pump that is what it should be replaced with.

Apr 13, 2009 | 1994 Mercury Villager

Not finding what you are looking for?
1994 Mercury Villager Logo

Related Topics:

1,149 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

fordexpert

Level 3 Expert

5520 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...