Question about Chevrolet S 10

1 Answer

I HAVE A 1996 S-10 IT RUNS ROUGH. IT ACTS LIKE IT RUNNING ON 2 CYL. I TOOK IT TO A MECHANIC HE PUT ON HIS COMPUTER,WITH EGNITION ON HE SAID #1 CYILNDER WERE MISFIRERING. WHEN HE STARTED THE ENGINE HE GOT NO DATA. I REPLACED #1 INJECTORS,COILS,PLUGS & WIRES,RUNNIG OUT OF OPTIONS.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 1,111 Answers

Sometimes while driving the vehicle you may hit a bump or pothole causing a wire to jiggle just enough to cause said occurrence as while merely sitting there with the analyzer on it nothing will show very common for this to happen at this point its hard to say ..however make sure all the plug wires are properly seated upon the plug even still the wires are new they also are not always without defects use a spray bottle with water and spray the wires to see if and arch is visible on the wires themselves also make sure the obvious wires etc are where they are supposed to be or a wire that is exposed to start with as well as check over all the vacuum lines for wear or rot due to heat ....would love to know what you discover

Posted on Sep 09, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What if I had a mobile mechanic replace my fuel pump, fuel filter and gave it a tune up but, the check engine light came on and when vehicle is running it runs rough or surges do you the the timing is off?


Take the intake manifold off and replace the 6 ignition coils. While you're right there, replace the top & bottom intake manifold gaskets too - 12 in total. Very easy job, only takes 2 hours all-up, but your mechanic will charge you a fortune. Learn to do it yourself - I'm no mechanic, but quite practical. Took me 2 hours and the car runs like new now. Was running like yours.

Jun 27, 2014 | 2001 Ford Escape

1 Answer

2001 Taurus 24Valve DOHC that runs rough, no power off stand still


Wow, all of those parts, and did the mechanic check the fuel pump pressure ??
The a/c problem is another issue.

Jun 29, 2012 | 2001 Ford Taurus

1 Answer

When sitting there or after driving and coming 2 a red light or stop sign it acts like its going 2 stall or die i took it 2 autozone put it on the check engine reader and they said it was the EGR value


EGR valve controls the amount of gas to oxygen ratio. this is a must to keep the car running smooth. to much or to little of either will make it run rough or sputter. you need to take it to a mechanic and have it replaced. it is an inexpensive part and labor shouldnt be to much either.

Dec 16, 2010 | 1999 Mercury Cougar

1 Answer

Check engine light and knocked off rockers


Running rough and misfiring is usually a one or more bad spark plug wires. Don't go back to that dealer. Replace the wires or have your mechanic do it for you. If you replace them, take one off at a time and install the new one. If you put the wires back on in the wrong order, it will misfire.

May 25, 2010 | 2003 Jeep Liberty

1 Answer

1999 intrigue GLS 3.5- Runs rough. The guy I got it from was told the cat convert was bad so he gutted it. Still runs rough. I took it to Autozone and the codes read "bad cranshaft position sensor" and...


Try the cheapest Fixes first 1) change the air filter. 2) change the fuel filter. Add 1 can of B&G44K to a full tank of 91 octane fuel. This additive is the best on the market and only available through dealerships(Do not substitute). It will condition the fuel pump and injectors. Try this first, Then redo the ODBII test. Erase all stored faults after reading. Put a dab of RTV on the bare wires at the crank sensor to insulate wires.

Mar 20, 2017 | 1999 Oldsmobile Intrigue

2 Answers

03 Altima ( 2.5 ) crank position sensor - retired ASE Master Teck


does the check engine light flash or is it on when the car misfires?? Bythe way, Nissan has a new program available for your ECM/computer for the long cranking condition. Check with your local NIssan dealer. Also spark plugs are rated for 105K, You have 110K on it. Check your plugs and make sure, that you use NGK if they need to be replaced. Also, look at your overflow bottle. If its down, top it off to FULL mark and monitor the level for few days. See if it goes down in like a week. I have seen some headgasket problems, where the coolant gets into the cylinders and drown the spark plug, causing a misfire. Let me know what you find. Lets get to the bottom of this and lets fix it.

Aug 27, 2008 | 2000 Nissan Altima

1 Answer

Idles rough ,loss of power ,sounds like its running on 2 or 3 cyl. changed fuel filter no diff. maybe a bad coil, 2003 beetle 1.8 turbo 4 cyl


I had this same problem on mt 2004 jetta. It had 85,000 miles on it. one day it bagan to idle rough but seemed fine when at higher sppeds/rpms. after a weekm I took it to the dealership and it turned out that a few of the coils/springs were shot. they also replaced my spark plugs, costing me about $550 total. But the car runs great again.

Aug 17, 2008 | Volkswagen Beetle Cars & Trucks

1 Answer

Running rough


what engine is this diesel /petrol

Aug 11, 2008 | 1997 Land Rover Discovery

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

72 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...