Does radius arm brackets for 92 explorer come together or do you have to buy them seperate

the ball joint is replaced as a lower control arm. You will need to remove the tire, remove the nut that attaches the ball joint to the knuckle, seperate the ball joint from the knuckel, remove the radius arm nut, remove the bolt that secures the lower control arm from the subframe, and then remove the control arm.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

If you support the truck by the frame with a jackstand,you can just change the bracket,there is no tension on the arm.

could be numerous problems without getting any info to diagnose but a common problem is the radius arm bushings.

76lb/ft on the upper and lower nuts

bad bushings most like the radius arms

you need to do what i call a dry check i do before performing an alignment have someone sit in truck and shift steering wheel from side to side lightly while you look at steering components check for loose pitman arm,drag link if used inner tie rods outer tie rods or excessive play in steering box then jack up each front wheel and check upper and lower ball joints

the most probable cause of that clunk is the radius arm bushings need replacing i have done LOTS of those . if you are not a mechanic or have limited skill this repair is fairly difficult..( not being rude just trying to save you a headache ) the radius arm extends rearward from front axle to frame..one on each side . look at the bushings where it goes through the frame bracket there should be a rubber bushing on both sides of that frame bracket and they should be compressed with no gap.. i hope that helps

Radius Arm Bushings. Best to do both sides, not a cheap job

There is a few things that can cause that,..#1 is the axle shaft universal could be worn out and to check it grab the axle shaft and try to twist it back and forth to check if its loose..#2 could be the brake caliper loose or the brakes are moving around in the caliper,#3 also could be the radius arm bracket cracked at the radius arm itself which is about a $25.00 part (not including the bushings which are about $15.00 a set)check these things as my 94 Bronco has been through all of every sound and clunk with 230,00 miles

they have what are called Radius Arm Bushings.That cause this problem and other vibration problems also. Go to Explorer forum com site for info on how to replace the.