Question about Nissan Pickup

1 Answer

I have a problem with my 2000 nission truck can u

I have a problem with my 2000 nission truck can u help me i replaced the distributor and cap, plugs and wires it, ran for about 20 minutes and then died and wont start

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 5,081 Answers

when you turn the key do you hear a click (behind the firewall), but the starter would not do anything, then the problem is with battery. Sounds like you aren't pulling enough juice from the battery. Check the water level in the cells and do a load test.
Try replacing the starter also.
ifthat doesn't do it, check to ensure that you have a good ground on the firewall and check the connections to the solenoid.

Posted on Sep 09, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 Chevy Blazer LS. Distributor is arcing and causing missfires. Plugs, wires, and distributor assembly replaced. Still arcs. Any deas


The distributor CAP is what is arcing. Non-AC Delco caps will do this. I chased my own "arcing" for months. Evidently there is a known problem with aftermarket caps arcing. I went through many caps until I learned of this. Swapped to AC Delco brand, solved all problems.

Feb 02, 2017 | Cars & Trucks

1 Answer

2000 S10 2.2l 2wd bucks and hops in low gears mainly then smothes out


Hmmm, sounds like the problem I just went through. Took me a while to figure it out. If your distributor cap isn't AC Delco OEM, this will happen sooner than later. Autozone caps are the WORST, won't last very long until you have internal arcing. By the way, other brands including Autozone seem to work fine, in OTHER vehicles for me. This engine needs to have AC Delco Plugs, Cap, and Rotor. After replacing with a new cap, does this problem disappear for a while, then come back? Also, make sure the cap is screwed down correctly, use a mirror for the back screw. And finally, double check that the PLASTIC screw tabs on the distributor are not broke off, causing your problem of not seating well or tight. If your are broken (VERY COMMON), only Napa makes a distributor repair kit. It's a metal arch, that attaches from the bottom of the distributor, then the screws in the cap thread into this. Hope this helps, it eluded me for months.

Feb 04, 2014 | 2000 Chevrolet S-10

1 Answer

2000 Chevy Astro; power to distributor from the coil, but no power out the distributor. New rotar cap, magnetic switch and distributor and ignition control module, but still won't turn over. Help!


check if fire at the end of spark plug wire with HEI spark plug tester.It need 25000 volts to jump the tester. If ok check for fuel injectors by pouring a little fuel inside intake .

Sep 19, 2013 | 2000 Chevrolet Astro

1 Answer

2000 blazer will not start did a manifold gasket job, replaced plugs, wires, distributor cap,new fuel filter. Cranked and ran really good for 2 days then will not crank


Check you starter, maybe you have a loose connection. Try to give direct power to the starter and see what's happening. I nothing happens, you have a bad starter.

Mar 16, 2013 | 2000 Chevrolet Blazer

1 Answer

2000 gmc truck spits and sputter when exceleratoring


what have you done so far ? tune it up ! replace air & fuel filters, spark plug wires & plugs, distributor cap , rotor , ignition module @ distributor, also replace theEGR valve , its garbage right now ! you will see when you take it off ! when replacing the ignition module, apply some silicone lubricant on the distributor base, under where the module is mounted, it will help to protect it from over-heating ! important ! check all VACUUM LINES, tighten throttlebody bolts to intake manifold ! changed your oil / filter lately ?

Mar 14, 2013 | 2002 Chevrolet TrailBlazer

1 Answer

My 2006 gmc sierra 4.3 is hard to start. replaced the distributor cap and rotor button,coil,plugs and wires. got it going this morning by putting a hair dryer near the distributor cap for 10 mins. what...


2006 ? distributor cap ? you sure about the year here ,Sorry but iam a europeon mechanic whos never seen this car but i dont see dizzy caps on vehicles from about 2000 onwards

Jan 03, 2013 | GMC Sierra Cars & Trucks

1 Answer

Is it hard to change distributor on 2000 nissan pathfinder


Hi there;This is for a 2000 Nissan Truck Pathfinder 4WD 3.3L SFI 6cyl


Distributor Cap & Rotor - Removal & Installation


NOTE
The 1996-00 3.3L engines were equipped with a distributor.


Disconnect the negative battery cable.
If the distributor cap is to be replaced, mark the ignition wires for identification and remove them from the distributor cap.
Remove any components necessary to access the distributor cap.
Completely loosen the distributor cap mounting fasteners.
Carefully remove the distributor cap, taking care not to damage the cap seal or rotor, then position the cap aside.
If necessary, remove the rotor retainer.
Carefully lift the rotor off the distributor shaft.
NOTE
Inspect the distributor cap to housing seal for damage and/or cracks. Replace if cracks are detected.




To install:


Install the rotor onto the distributor shaft and tighten the rotor mounting fastener, if equipped.
Position the distributor cap seal on the distributor housing, then position the distributor cap on the housing.
Install the distributor cap by tightening the mounting fasteners in a crisscross pattern. Use care to not over-tighten the fasteners.
Reconnect the spark plug wires, making sure to install them exactly in the same position from which they were removed.
Reconnect the negative battery cable.

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Jun 06, 2012 | Nissan Pathfinder Cars & Trucks

1 Answer

How to install cap and rotor on a 2000 chevy blazer 4.3ltre v-6


Disconnect the wires and take pictures with cell phone for reference to ensure you don't cross them when reinstalling the new distributor cap. Remove the two torque screws in the distributor cap and remove the distributor cap to access the rotor. Remove the rotor by lifting straight up and inspect the distributor for any condensation and corrosion. Clean the breather screen at the bottom of the distributor before installing the new rotor which just slides back in place. Install the new distributor cap and tighten the new torque screws, make sure you do not over torque the screws since the distributor housing is plastic and prone to stripping. Reattach the spark plug wires and start the engine and idle for 5 min and go for a test drive. Good luck and you may want to also buy spark plug boot lubricant to ensure the spark plug wires are fully installed when placed back on the new distributor cap and recheck connections after test drive. Keep me posted, be glad to know your blazer is running 100% and please rate.

Jan 10, 2010 | 2000 Chevrolet Blazer

2 Answers

Won't start under moist conditions


Has the head gasket got a leak?

Sep 14, 2008 | 2000 GMC Sierra

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

54 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...