Question about 2004 Chevrolet TrailBlazer

1 Answer

All gages has stoped working - 2004 Chevrolet TrailBlazer

Posted by on

  • yadayada
    yadayada May 11, 2010

    have you checked the guage fuse?

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 13 Answers

Check fuses

Posted on Sep 09, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I cant find the fuse box in my 2001 caravan.


there might be one on the inside either on the driver side under the dash or the passenger side

Aug 13, 2012 | 2001 Dodge Caravan

1 Answer

I perchesed a dodge caravan from a car lot. so far I put on tires, Oil change. and a new water pump. my gages started working again. Now all the gages stoped working and only thing working is the turn...


Stop changing things or you'll think you caused it. Likely your dash came unplugged from the wall or a bad grounbd going to it. Hold your breath, now the fun begins. Chances are this is intermittent.

Apr 23, 2011 | Dodge Caravan Cars & Trucks

1 Answer

The turn signals speedometor and rpm gage stoped working i have replaced the cluster and the turn signal switch and still not working


What you need to replace is the speed sensor. That has gone bad.
Please don't forget to rate me.. this will help me

Mar 03, 2011 | 2001 Oldsmobile Aurora

1 Answer

My heat gage quit working and my speedmeter quit to as my gas gage to what coud be wrong they all stoped at once and no dash light


That dash board uses ribbon connectors to connect to the wiring harnesses. Make sure the connectors haven't come free. You can pick up a used one that works from a parts yard for about $25 and replace the old one. This all assumes that the fuses for the dash are in good working order. The only reason I recommend replacing the cluster is because you lost too much at once and this could be caused by a short on the board that controls it all.

Feb 28, 2011 | 1995 Plymouth Voyager

3 Answers

Does any body know why my speed gage and rpm gage doesn't work on my 2001 dodge caravan


mine stoped working and i had to do a cluster diagnostic by pushing and holding the milege reset button untill the diagnostic test starts this might solve your problem

Oct 23, 2009 | 2001 Dodge Caravan

1 Answer

2003 silverado 1500 HD ran out of gas and i put in gas and it won't turn over why? the fuel was low I stoped at a light and the truck coughed twice and died. I put in 5 gallens of gas and the gas gage wont...


If the starter doesn't turn over the battery is dead or you need to replace the starter.

The gas gage not working is caused by the fuel level sender located in the fuel tank this will also need to be replaced.

Aug 02, 2009 | 1999 Chevrolet Silverado 1500

1 Answer

Oil gage fluttered and then stoped working


most likely this is just a defective oil pressure sending unit, replace it.

Jul 15, 2009 | 1999 Ford Explorer

1 Answer

'96 Firebird


hey
Have you had done or done any electrical work lately? It would appear that yes, either the daytime running light relay, or an auto-shut off relay is confused and it energizing when it is not supposed to.
i suggest to Take it to the dealer, they will know what to do.
other thing that can be possible is:electrial schematics and trace the control system for the lights. Most likely, if you have done electrial work, then it is a crossed wire. If not, then either a bad relay, or bad computer module is at fault

Jul 13, 2008 | 1996 Pontiac Firebird

Not finding what you are looking for?
2004 Chevrolet TrailBlazer Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...