Question about Dodge Intrepid

1 Answer

2000 intrepid air blows cold but only on the floor, it wont adjust to top or middle, just floor, help?

Posted by on

  • foster_larry Sep 08, 2009

    im sorry but that doesnt give me any answers to MY problem!

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Champion:

    An expert who has answered 200 questions.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 217 Answers

Sounds like a mode door needs to be investigated on the heater box

Posted on Sep 09, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

What is causing my car to blow cold air from heat. them it over heats while blowing cold air when hot air does blow car runs fine no overheating please help. 2000 Monte Carlos 3.4


more than likely your losing cold water from your water system, make sure your water pump is up to scratch...sounds strange, but you need cold water for heat through your air conditioning...

Jan 21, 2015 | Cars & Trucks

1 Answer

My 2005 ford focus wont blow out heat, also it only blows cold air to the floor,


Hi,
There is likely a 'blower resistor' that is blown related to the Fan setting. The Temp setting may be due to low Coolant/Anti-freeze - WHEN the car is COLD - has not been running for 4 hours - check the coolant level - not in the overflow/reservoir - but in the radiator. Take it to a shop if you're not familiar.

GL,
TD

Oct 01, 2012 | 2000 Ford Focus

1 Answer

Passenger side only blowing cold air.


You need to replace the "blend" door actuator motor on the pass side. I recommend getting that from your nearest gm dealer to ensure proper fit. When you adjust the air from cold to warm to hot, the blend door moves to direct the right amount of cold, or warm, or hot air your desire on that side of the vehicle

Dec 04, 2009 | 2000 Buick Regal

3 Answers

Shooting oil out of dipstick


Your engine breather system is blocked....this means that the only way that the compression caused on ignition that is getting past the piston rings and into the block can escape is via the dipstick tube.
Check breather for kinks and some have filters ensure that these are not blocked

Oct 03, 2009 | 2000 Dodge Intrepid

1 Answer

2002 dodge intrepid air conditioner


How did you check your pressure? A proper way to charge a/c is to evacuate the system, which is removing all the refrigerant, and vacuum it down to remove all moisture. Then recharge with the proper amount of refrigerant.
Or, your drain for the evaporator can be plugged. Have it checked first.

Jun 19, 2009 | 2002 Dodge Intrepid

2 Answers

I have a 2000 Dodge Intrepid 2.7L DOHC Engine - Climate Control


Might be the same....You may want to do the diagnosis proceedure. Alot of times its the door actuators. Servos in replace of old cable design. Usually it will be a code 46. DOOR BLEND ACTUATOR SHORT TO BATTERY.
The DTC's can be checked with the MTC control and the Odometer Display of the Mechanical Instrument Cluster if a DRBIII® scan tool is not available. The MTC control can only be placed into the diagnostic mode while the engine is running and the vehicle is not moving. To place the system into it's diagnostic mode, adjust the MTC control to the following settings:
  1. The engine must be running with vehicle not moving.
  2. The fan speed set to any speed except OFF.
  3. The temperature control knob in full cold (full counterclockwise position).
  4. The mode control knob must be placed in Defrost position (full clockwise position).
  5. The A/C button can be On or Off.
  6. Press and hold the rear window defogger (EBL) button until the mechanical instrument cluster odometer display indicates an "AC00". The BCM will chime once and the MTC A/C button LED will begin blinking.
  7. Release the EBL button and wait until the MTC A/C button LED stops blinking. This means that the error check and climate control door calibration is complete. NOTE: It is important that no other control knob or button is pushed until all DTC's are read. Pushing any button except the A/C button or turning a control knob will end the diagnostic test without showing the rest of the DTC's. There also may be other DTC's stored in the BCM not related to the climate control system. These DTC's can only be found using the DRBIII® scan tool.
    DTC's related to the MTC control head will appear on the odometer display in numerical form after the letters "AC". The odometer display will return to normal operation if no DTC's are found. If a problem is found, then the odometer will display the letters "A/C" followed by the DTC number. The odometer display can only show one DTC at a time. Under certain circumstances, more than one DTC could be in the memory. To scroll through any additional DTC's, press the A/C button on the MTC control. The BCM will beep each time the A/C button is pushed. Continue pushing the A/C button and recording the DTC's until the odometer returns to normal operation (note the letters AC will dissapear.

Jun 15, 2009 | 2000 Dodge Intrepid

2 Answers

Heat wont blow through heater or defroster vents


Had the same problem. believe it or not i changed the gas cap and got heat all around. something about pressure.

Dec 05, 2008 | 1993 Chevrolet Corsica

2 Answers

Car only blows cold air


Check temperature heath controltemperature heather controlNTREPID Temperature/Heater Control 2000

Dec 04, 2008 | 2000 Dodge Intrepid

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

108 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...