Question about 1995 Ford F150 Styleside Regular Cab

Open Question

No power at fuel injecters on a 1995 ford f 150 with 302 engine

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 29 Answers

SOURCE: 1995 ford ranger 3 .0

It can possibly be oil getting into the piston fire area. Maybe a leaky valve seal, or head gasket? Possibly rings?

Posted on Sep 23, 2008

B-Roosky
  • 59 Answers

SOURCE: where is the fuel pump on a 1986 ford bronco II

the pump is on the top of the fuel tank and goes down inside the tank from there.

you have to drop the tank to get to the fuel pump.

Posted on Jan 11, 2010

kirkx
  • 2019 Answers

SOURCE: On my 1992 Ford Aerostar 3.0 Engine (fuel

In the old days, I would have said a leaking fuel pump diaphragm, but that can't happen anymore.

Assuming the engine does not run as rough as one with a bad plug would be, then I would suspect an injector.
If an injector does not seal up when off, then about a pint of gas will slowly drip into the crankcase every night.

Remove the injectors from the manifold, but leave on the fuel rail. Then turn the key or shunt the relay in order to turn the fuel pump on for a few seconds. The injectors should only fire intermittanly when their time comes. After that there should be no drips. If one is dripping or has a bad spray pattern that is not a cone, replace it.

Posted on Jun 03, 2010

  • 27 Answers

SOURCE: 1988 Ford Bronco fuel injection system isn't getting power to it

i had a similar problem that ended up being the fuel pump relay located in the engine compartment on the drivers side next to the air box. there will be at least 2 relays, the fuel pump one is black and brown. check that first.

Posted on Aug 01, 2010

  • 26 Answers

SOURCE: I need to change a fuel pump and filter in a 1995

Have you tried one of the aftermarket automotive repair manuals such as Haynes ? ( check spelling ) I find them to be excellent for the do-it-your-selfer.

Posted on Jul 13, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

No power at fuel injecters on 1996 ford explorer 4.0 engine 4 wheel drive


Check and see it it has a cam sensor. If it does then that could be bad.

Dec 31, 2011 | 1996 Ford Explorer

1 Answer

Need vacum hose dirgam for subaru impraza 1995


Hi Stephen:
I suggest chgeck this links diagram:
- Vacuum diagram - 1992-95 1.8L fuel injected engine
-
Vacuum diagram - 1995 2.2L fuel injected engine
- Vacuum diagram - 1995 2.2L fuel injected engine (continued)

Hope this helps; also keep in mind that your feedback is important and I'll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using Fixya, and have a nice day.

Dec 14, 2011 | Cars & Trucks

1 Answer

I am doing repairs on a 100 series toyota diesel l/cruiser. my problem is, that i've changed a seized engine (2004 model) with a (1995 model), and both engines are the 100 series 1hz diesel range. But the...


better chec the wiring or connections 1st--pull the plug from the pump and inspect for flaws and corrosion then plug back in--pump itself can be tested--the fuel injection pump in engine area may have issues

Feb 28, 2011 | GMC Suburban Cars & Trucks

1 Answer

1995 ford 360 powered motorhome runs great for the first 10 miles then it runs out of power,idles fine put it in drive and it bogs out,when it sits for a while its ok again


Motorhomes are notorious for high heat buildup in the engine areas. There is normally not enough air flow in and around the engine which causes this condition.

My immediate thought is that the engine might be having a fuel heating problem. If fuel heats up too much, it turns to a vapor and then the injection system cannot perform its job. Look for some flexible, metallic insulation at your parts store and see if insulating the fuel lines from where they enter the engine compartment up to the injector rail provides any relief. I assume that at this point, fuel pressure has already been tested and found to be adequate.

May 03, 2010 | Ford Super Duty Cars & Trucks

1 Answer

1988 Ford Bronco fuel injection system isn't getting power to it


i had a similar problem that ended up being the fuel pump relay located in the engine compartment on the drivers side next to the air box. there will be at least 2 relays, the fuel pump one is black and brown. check that first.

Jul 07, 2009 | 1988 Ford Bronco

1 Answer

Fuel filter location for 94 ford escort lx


on the fuel injection engines the fuel filter is located in one of 2 places 1, under and to the rear of the engine above the drive shafts or 2, under the car at the rear just forward of the rear suspension assembly

Apr 25, 2009 | 1995 Ford Escort

3 Answers

Starts when cold, won't start once it's warmed up.


take it to a diesel injection shop. the high end oil pump is out in the injection pump.

Mar 10, 2009 | 1995 Ford F250

1 Answer

Firing order


Which engine do you have in your truck. Ford had a couple of firing orders as per engine that was installed.

Jun 11, 2008 | 1995 Ford F150 Styleside Regular Cab

Not finding what you are looking for?
1995 Ford F150 Styleside Regular Cab Logo

Related Topics:

36 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5501 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...