The Drivers window button sometimes wont work?

fuse 4
http://www.carpartdiagrams.com/wp-content/uploads/2012/05/Fuse-Panel-Diagram-Ford-Explorer-2000-fuse-panel.gif

sounds like a bad switch on the drivers door panel seeing as how they all work from there own doors

Its not a fuse its the button on window .now first remove the button its self, try to raise window now . if it dose not work its the window switch replace the switch that controls 4 windows in drivers door

Always power a stereo device off of a fused accessory circuit at the fuse block. Never tap into a harness or wires under the dash

if your going to do it your self buy a haynes or chilton do it yourself book eather at half priced books or auto parts store .
the driver side gets the most work out most times door open shut most times exposed to the element and coffe and soda at the drive threw eather a short or up and down need cleaned .you can clean them with a can of electrical parts wash from your auto parts store run 9$ to 14$ .when you are going to remove the controle assemble from the arm rest make shure you disconect the neg from the battery. give it a good washing let dry put back and re-attach battery. if that dont work try to replace that driver side up down button or try to take it appart and clean it better .

The drivers switch on GM cars has the window control module built into it. This is more than likely your problem, it is very common for this.

pull the control switch out n clean contacts or try and spay contact cleaner on them

It won't work on either the drivers button or the passenger button? If so it's the motor, if it works on one of the buttons then it the button that won't put it down. Let me know please.

Turn on the rear window wiper . Try to get the wiper arm off the glass. There is a switch that will not let the window operate if the wiper is on the glass.

try checking the switch that controls the up and down, I just had the opposite problem with my 2003 venture the window would not roll down, the garage put in a new switch for the part was about 75 dollars. it took about an hour to fix.