Question about 2009 Pontiac G5

Open Question

The remote did not work so used the key to open door, put key in ignition and attempted to turn the car over...battery completely dead, no clicking noises or any sound. Key stuck in ignition. (Pontiac G5 2009)

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Vehicle entry problem


THAT really sounds like someone is pranking you by swapping your car for another car just like it.

Aug 05, 2014 | 2001 Mazda 626

1 Answer

How do you enable a range rover engine when key battery is flat


There is a sequence of left and right turns of the key in the driver's door that will reset your bECM (Rovers brain) if the following have been tried.
1. Replace batteries in remote and 're-sync by depressing lock button on remote while physically turning and locking the door. Don't release button until locked and key removed. Repeat for unlock button.
2. Disconnect negative/earth cable from battery. While disconnected open driver's door, turn ignition to position 2, return to battery leaving driver's door open and reconnect the negative cable. Proceed to ignition. Turn off completely. Close all doors and hood and attempt starting.
Should both of these methods fail, run a search here on fixya for "engine disabled Range Rover P38" This will take you to step by step instructions on resetting the bECM which I opened this post with. It has been covered many times here, including by myself, no reason to post it again.
Good Luck!

Jul 14, 2014 | 2000 Land Rover Range Rover

1 Answer

How to re-start my car after anit theft light has come on?


you need a full charged battery or battery replaced [if battery bad and not holding charge] your remote key fob will not work if battery is dead or to weak to start car but key should be able to manually open drivers door --if its not an original key new cut or worn down [may have to jiggle in door ] your anti theft/security lock will come on when you use key in door than you have a few seconds after you open door to put key in ignition and turn to on position before alarm goes off but you need to get battery issue corrected first if key still doesnt work may need to have assistance [slimjim]lock to get in

May 12, 2014 | 2007 Chevrolet Epica 2.0

1 Answer

I think my key remote is dead and my key won't open the door. what can i do?


put a new battery in remote,try key in other door," are you sure the car battery is not dead," !!!! If it is then remote wont work, if you are locked out of car call wrecker or lock smith and they can slim jim the door to get you inside. then unlock doors USING THE POWER LOCK button PROVIDING CAR BATTERY IS NOT DEAD!!!!

Jan 14, 2011 | 1999 Lincoln Continental

2 Answers

My mercedes s 430 2001wont let the remote key turned everything was fine the everything went dead


If you mean key will not turn in ignition,charge or jump start
Car has electronic ignition switch
If battery is low/flat it will not turn

Apr 27, 2010 | 2001 Mercedes-Benz S-Class

1 Answer

Tryed to change the battery in my 2000 Volkswagon Passat


There is a way of running it by putting the spare key in the ignition and turning the ignition on but dont start the car, put the second key in the drivers lock and turn as if you are opening it until you hear 2 beeps, then press the unlock button on the remote while in the door.The car should beep once and flash the indicator lights.Remove the door key and remove the ignition key then lock the car using the remote.Open the car and try the ignition.Some systems lose the memory of the key chip so this may help you but with technology it works for some and not for others.

Feb 13, 2010 | 1999 Volkswagen Passat

3 Answers

THE BATTERIES WERE DEAD IN REMOTE FOR KEYLESS-ENTRY


This works on the older troopers min is a 95 giv it try
A-Open the driver’s door.
B-Insert key into ignition.
C-Turn the ignition switch to the ACC position and then to the LOCK position three times. (This step must be completed within 3 seconds – go as fast as you can, or the system will not enter the programming mode.)
D- Within 10 seconds, close and open the door two times.
E-Turn the ignition switch to the ACC position and then to the LOCK position three times (again, do this within 3 seconds.)
F-Within 10 seconds, close and open the door. Verify that the power door locks cycle once to confirm that the system is in programming mode.
G-Within 20 seconds, press the LOCK button on the transmitter you are programming. Verify that the door locks cycle once.
H-Within 20 seconds, press the UNLOCK button on the transmitter. Verify that the door locks cycle once to confirm that the system has accepted the transmitter’s code.
I-Repeat steps 7 and 8 for each transmitter to be added. Remove key from ignition.

Oct 16, 2009 | 2001 Isuzu Trooper

4 Answers

Program a remote key for 03 A6


I have an A4 and did this to re-program my key:

1. used the key to start the car...then turned it off
2. put the key in the driver door (door closed)
3. pressed the lock button on the key fob once
4. turned the key to lock the door.

This is basically the steps in the owners manual, but the car must be started with the key first, and the key must be in the door lock before pressing the lock button.

Dec 10, 2008 | 2003 Audi A6

1 Answer

Key will not unlock door


the lock on the driver side could be damaged or some on might have used a jimmy to open that door before how evr you have to open the pannel and remove the lock cylinder part and make sure that the key is working or yo must change the tumbler s in the lock to fit your key (lock smith)

Nov 19, 2008 | 2002 GMC Envoy

Not finding what you are looking for?
2009 Pontiac G5 Logo

Related Topics:

441 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

76051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8265 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...