Question about 1999 Chevrolet Silverado 1500

1 Answer

I have a 1996 silverado 5.0 that won't start. I have checked the fuel pump, checked the fuel relay and replaced the fuel filter. I have fuel to the pressure valve at the top of the engine. It will turn over after pouring gas into the throttle body, but will die once the fuel is burned. I have run out of ideas. Not real familiar with the fuel injection system, so I dont know what to check next.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 13 Answers

Might be a bad injector or one whole side of the fuel rail. For some reason fuel isn't getting into all the cylinders.

Posted on Sep 09, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1996 chevy silverado 2500 every once in a while it will stop running,when i pull the fuel pump relay out and put back in it starts back up. it is very warm to the touch,just noticed today tha


I would just replace the relay. Then if it still happens, your fuel pump is drawing too many amps. Causing the relay to overheat and shut off. Time to replace the pump, before it dies on you.

Sep 09, 2014 | 1996 Chevrolet Silverado 2500

1 Answer

2002 chevy 3500 duramax 6.6 ran hot now cranks but won't start


Check spark plugs, leads, distributor cap & rotor arm, fuel pump, fuel filter, coil pack(s), relays, replace any items that are suspect IE Fuel filter which has probably not been changed since new even though they should be changed on all vehicles every 18 months, all of this can be done at home & will save you a lot of bucks in mechanic/garage fees,

Sep 21, 2012 | 2002 Chevrolet Silverado 3500

2 Answers

1997 chevy silverado 1500 350 vortech, new fule pump not working


before you drop tank again, check fuses & relay.then disconnect fuel line @ filter turn key to on position should hear fuel pump run and get gas stream out of line. if no flow from line new pump faulty be sure & remove negative battery cable first good luck.

Jun 04, 2009 | 1999 Chevrolet Silverado 1500

1 Answer

The engine turns but the car won,t start.


You will need to check for fuel pressure or dirty filter. If you do not have fuel pressure; be sure to check fuses or any relay pertaining to fuel pump (if electric). If fuses and relays are good check or replace fuel filter. If the fuel pump is mechanical disregard fuses & relays and check or replace fuel filter. If this does not resolve the problem then the problem could be the fuel pump if mechanical, If its an electric fuel pump it could be a fuel pressure regulator, fuel pump, crimped fuel line or other wiring issue.

These are the most common things I run across, oh, a crimped fuel line can cause the problem in either case electric or mechanical. Hope this helps in some way, been awhile sense I worked with an older car.

Apr 05, 2009 | 1986 BMW 5 Series

1 Answer

FUEL PUMP FOR CHEVY SILVERADO


fuel filter? how about power to the fuel pump,loose ground wire to chasis? wiring harness? terminals clean at point of connection?did you check the fuel pump relay? Relay is located in electrical center under the hood on the driver side.relay and fuse legend will be on bottom side of cover, you sould be able to switch with another relay that you know works, ie: switch horn relay with fuel pump relay, honk horn to insure both relays are working when either relay is inserted into horn slot. Do you by chance have the electrical schematic drawing for the fuel pump?

Feb 17, 2009 | 2000 Chevrolet Silverado

2 Answers

1996 silverado 5.7 vortec cranks but wont start. fuel pump, gauges, "idiot" lights, blinkers do not work. flashers and all the rest of lights operate. Just replaced coil and this happens


Had the same problem with my '96 Silverado with 350 Vortec. The truck would only crank. It would start if fuel was poured down the throttle body. Could not hear the fuel pump hum. Fuse was good, but could not hear relay click. Relay was good, Did some electrical wiring trouble shooting. Turned out that one of the connectors that clasp onto one of the pins of the fuel pump relay wasn't making a good connection, too loose. I just stuck a peice of wire into the connector and pushed the relay back in. Relay clicked, Truck Started. It's been more than 4 yrs. since I made that McGuyver fix. Still firing.

Jul 26, 2008 | Chevrolet Silverado 1500 Cars & Trucks

Not finding what you are looking for?
1999 Chevrolet Silverado 1500 Logo

116 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...