Question about 2007 Buick Terraza CXL Wagon

Open Question

Same issue - 2007 Buick Terraza CXL Wagon

Posted by on

  • monkeytil May 11, 2010

    please elaborate on your question

×

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2007 silverado, check engine light works intermit, also miss fires intermit


Does the CEL "work" intermittently, or it comes on intermittently? If it comes on intermittently, that's telling you that the PCM has identified an issue and there will be a stored diagnostic code that should point you in the correct directly to begin troubleshooting. For example, if there is a stored code of P0304, that means the PCM has determined based on sensors that cylinder #4 has a misfire. You will then need to determine if that misfire is due to a spark plug issue, a coil issue, a coil/plug wire issue, fuel injector issue, compression issue, or vacuum leak.

Nov 06, 2017 | Cars & Trucks

1 Answer

No hadlights or taillights


Connection issue ground issue fuse issue or just bulb issue

Sep 11, 2013 | Cars & Trucks

1 Answer

2001 dodge 2500 5.9l 4 speed automatic shift problems


For car not changing gears it can be shifter assembly issue, or it can also be transmission issue. Get the shifter assembly inspected with ignition OFF.

For more troubleshooting, I suggest you to get the Following help link checked, its complete step by step procedure to inspect gear shift issues: -----

GEAR SHIFT ISSUES

http://alltypesofpartsreplacing.blogspot.com/2012/11/gear-shift-issues.html

==========

These will help.
Thanks.

Feb 15, 2013 | Cars & Trucks

1 Answer

My 99 denali quit shifting into overdrive. Everything still seems pluged in. Any suggestions?


For car not changing gears it can be shifter assembly issue, or it can also be transmission issue. Get the shifter assembly inspected with ignition OFF.

For more troubleshooting, I suggest you to get the Following help link checked, its complete step by step procedure to inspect gear shift issues: -----

GEAR SHIFT ISSUES

http://alltypesofpartsreplacing.blogspot.com/2012/11/gear-shift-issues.html

==========


OD light flashing and transmission fluid leaking?

http://repairhelpcenter.blogspot.in/2012/02/od-light-flashing-and-transmission.html
------------

These will help.
Thanks.

Feb 15, 2013 | Cars & Trucks

1 Answer

Torque coverter clutch circuit malfunction on mercedes benz 2003 c230 kompressor


For car not changing gears it can be shifter assembly issue,or it can also be transmission issue.Get the shifter assembly inspected with ignition OFF.For more troubleshooting, i suggest you to get the Following help link checked,its complete step by step procedure to inspect gear shift issues:-----

GEAR SHIFT ISSUES
http://alltypesofpartsreplacing.blogspot.com/2012/11/gear-shift-issues.html
==========
These will help.Thanks.

Nov 29, 2012 | Cars & Trucks

1 Answer

What is the meaning of a failing test with NOx(ppm)


Oxides Of Nitrogen (NOX)

Above 2500 degree engine combustion temperature
nitrogen bonds to oxygen to form NOX

The EGR Valve is supposed to allow a certain
amount of exhaust gases into incoming air to
control high combustion temperature and control
NOX

Bad Egr Valve
Engine operating too hot
Cat too cool at inspection station
Fuel mixture issues
PCV issues
O2 Sensor issues
Injector issues
Ignition issues

Jan 30, 2011 | Toyota Previa Cars & Trucks

1 Answer

I have a 2002 AWD Pontiac Montana and I have loud vibrating noise in the rear end.


OK. You could have a number of issues. Issue one could be cupped tires. cheapest. Issue two could be bearrings. And issue 3 could be a differential problem. Start with the smallest issue and x that out if thats not it keep going until you find it. But i hope that its either cupped tires and if not its probably gonna be a bearring issue.

Jan 30, 2011 | 2006 Pontiac Montana

1 Answer

PO406 ON 2003 FORD CROWN VIC. CHANGED EGR AND EGR CONTROL SOLENOID. ANY ADVISE ?


My 03 had an O2 sensor code and intermittent drivability issues; replaced Sensors and still had code and intermittent drivability issues. Two days later #1 Ignition Coil failed. Replaced the Coil and all issues are now resolved. My point is you may be getting the P code but what is the underlying issue. If there are drivability issues it could be as simple as a spark plug or an injector expressing itself in another manner. If you swap the plugs DO NOT Overtighten them! Good Luck! Let us know how you resolve this issue.

Oct 22, 2010 | 2003 Ford Crown Victoria

Not finding what you are looking for?
2007 Buick Terraza CXL Wagon Logo

Related Topics:

56 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8514 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...